Elmo P100HD Manuale Utente
35
■
Image selection
You can switch the input source either with the remote control or from the Signal select screen
displayed by tapping [ (Main menu)] > [ ] on the touch panel.
Camera image:
[ (Signal select)] > [ ] on the touch panel
[ ] button on the remote control
Image input from the
RGB IN1、RGB IN2、HDMI IN1、HDMI IN2
terminal:
[ (Signal select)] > [ ] on the touch panel
[ ] button on the remote control.(Only RGB IN1 is selected.)
Image stored on the SD card/USB flash drive:
[ (Signal select)] > [ ] on the touch panel
[ ] button on the remote control
N o t e
• When using a PC with external output mode switching, set it using the following
procedures.
1. Connect the PC to this unit.
2. Change the PC to the external output mode.
2. Change the PC to the external output mode.
3. Tap [ (Signal select)] > [ ] on the touch panel or pressing the [ ]
button on the remote control.
•
When selecting the image in [ Signal select (Normal)], output same image (resolution)
to [RGB OUT] and [HDMI OUT].
•
When selecting external input image, do not change the resolution of the input image.