Fujitsu C150-E049-02EN Manuale Utente

Set the time from when Start Command
Timeout limits until hopper table is lowered.
Set in EEPROM whether the heater control is
on or off.

17

Setting hopper
time

18

Setting heater
control

When you set the using of double-feed detection, you must set as follows.

4 At Screen 2, press [Mode 1] once to go to the

DOUBLE FEED CHECK screen. (Screen 4)

5 Press [Mode 2] to see Screen 5. If “ON” is

displayed, the error will be detected when the
double-feed is occured. If “OFF” is displayed,
it wouldn’t. The “ON” or “OFF” status flips
each time you press [Mode 2].

6 Press [Mode 1] to see Screen 6. This means

how to defect the double-feed as follows.
“1” is the method by comparing with the
length of the first paper.
“2” is the method by the output of
Document detection sensor in addition to
“1”.
At Screen 6, press the [Mode 2] until the
number changes as you want.

7 Press [Mode 1] to see Screen 7. This means

the length to compare with the paper based
on. If you choose “1” or “2” and set “15mm”,
the double-feed is detected when the scanned
paper length is 15mm longer than the first
paper.
At Screen 7, press the [Mode 2] until the
number changes as you want.
(You can choose 10, 15 or 20mm. The
default is 15mm.)

<< SETUP MODE >>

DOUBLE FEED CHECK

DOUBLE FEED CHECK

OFF

1

15mm

Screen 5

Screen 4

DOUBLE FEED CHECK

OFF

1

15mm

DOUBLE FEED CHECK

OFF

1

15mm

Screen 7

Screen 6