Nikon 4804 Manuale Utente
28
Procedures for close-up flash operation
1
Installing batteries in the SU-800.
1
Slide open the battery chamber lid
in the direction of the arrow.
in the direction of the arrow.
2
Install the battery, then close the
battery chamber lid by sliding it
back into place.
battery chamber lid by sliding it
back into place.
Use CR123A (3V) lithium batteries.
Confirming the close-up mode
setting
setting
Make sure that the Commander/Close-up
select switch in the battery chamber is set
to “Close-up” position.
Replacing the battery
The Low Battery-power Indicator blinks
when the SU-800’s ready-light does not
come on within about 30 seconds of
turning on the power or after the flash has
fired.
• Replace the battery.
Battery
chamber