Sony HKCU-903 Manuale Utente
1-12 (E)
HDCU-900 MM
1-5. Adjustment and Setting after
Replacing the Boards
After replacing each plug-in board, return the switches to
the setting before replacement. Also, readjust and reset the
following items.
the setting before replacement. Also, readjust and reset the
following items.
1-5-1. When Replacing the AT-141 Board
While referring to Section 2, “System Setup” of the
separate Installation and Maintenance Manual, readjust and
reset the following items.
separate Installation and Maintenance Manual, readjust and
reset the following items.
Adjustment and setting items
2-2-1. Setting the Intercom System
2-2-1. Setting the Intercom System
. Selecting the intercom system
. Setting the input level of the PGM audio signal
. Selecting an intercom line to be connected to the
. Setting the input level of the PGM audio signal
. Selecting an intercom line to be connected to the
INTERCOM connector
2-2-2.
Setting the Microphone
. Controlling the microphone input level from the
remote control
. Adjusting the microphone input level using the
MIC LEVEL switch
. Setting the microphone output level
2-3-1.
Setting the Tally System
2-3-2.
Setting the Camera Number
2-4-2.
Adjusting the Signal Phase
. Adjusting the sync signal phase
1-5-2. When Replacing the RC-86 Board
While referring to Section 2, “System Setup” of the
separate Installation and Maintenance Manual, readjust and
reset the following items.
separate Installation and Maintenance Manual, readjust and
reset the following items.
Adjustment and setting items
2-4-4. Adjusting the Level of Signals for Waveform
2-4-4. Adjusting the Level of Signals for Waveform
Monitor
. Adjusting the staircase signal
. Adjusting the staircase signal
If required, adjust the following items too.
2-4-4. Adjusting the Level of Signals for Waveform
2-4-4. Adjusting the Level of Signals for Waveform
Monitor
. Adjusting the WF Output Signal Level
. Adjusting the WF Output Signal Level
2-4-5. Adjusting the Level of Signals for Picture Monitor
1-5-3. When Replacing the DPR-163 Board
While referring to Section 3, “Electrical Alignment”,
adjust the following item.
adjust the following item.
Adjustment item
3-3-3. Clock (74 MHz) Duty Adjustment/DPR Board
3-3-3. Clock (74 MHz) Duty Adjustment/DPR Board
(Board suffix: -14 only)
3-3-4. Prompter Level Adjustment
1-5-4. When Replacing the IF-789A/789P
Board (HKCU-901)
While referring to Section 3, “Electrical Alignment”,
adjust the following items.
adjust the following items.
Adjustment items
3-5-4. GRB Output Level Adjustment
3-5-6. Return Level Adjustment
3-5-4. GRB Output Level Adjustment
3-5-6. Return Level Adjustment
While referring to Section 2, “System Setup” of the
separate Installation and Maintenance Manual, adjust the
following item.
separate Installation and Maintenance Manual, adjust the
following item.
Adjustment item
2-4-3. Level Adjustment of the VBS Signal
2-4-3. Level Adjustment of the VBS Signal
1-5. Adjustment and Setting after Replacing the Boards