Manualsbrain.com
  1. Manuali
  2. Marche
  3. Chauvet
  4. Camera Accessories
  5. Manuale Utente

Chauvet Camera Accessories Manuale Utente

Scarica
Pagina di 24
 
Operation 
Stand-Alone Mode (Sound-Active, Auto Mode): 
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto 
Mode. There is an LED indicator on the rear of the fixture which will indicate this mode. 
1. Use 
SET.A 
to choose the desired program. 
2. Use 
SET.S 
to set the speed of the current program 
3. Use 
SET.f 
to set the flash rate of the current program. 
Note: when there is no sound available, then the unit will automatically switch to auto 
mode. To change it into auto mode when there is sound present, then simply turn the 
sound adjustment knob fully counter-clockwise. 
 
Note: In the absence of DMX signal, the fixture will automatically revert to standalone 
mode. Plugging in a DMX cable that is connected to a DMX controller will automatically 
disable standalone mode and put the fixture into DMX mode. 
 
Note: In sound-active mode, the display will read 
SUND
. 
• 
The unit will react to the low frequencies of music via the internal microphone in Sound 
Active mode, or the unit will auto change in Auto Mode. 
• 
Use the audio sensitivity knob on the back of the unit to make the unit more or less 
sensitive in Sound-Active mode. Turning the knob counterclockwise decreases the 
sensitivity; turning the knob clockwise increases the sensitivity. 
Master/Slave Mode (Master Sound, Master Auto): 
This mode will allow you to link up to 32 units together without a controller. The first fixture in the 
daisy chain will automatically be assigned as the master, and each fixture following will be assigned 
as slave fixtures. 
 
Note: for this mode, you must not connect a DMX controller to the fixtures. 
 
Note: In sound-active mode, the display will read 
SUND
. 
1) 
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear 
of the units. For longer cable runs we suggest a terminator at the last fixture. For more 
information about terminators, see page 14. 
DMX Mode 
This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with 
DMX, please read the DMX Primer section in the appendix. The fixture will automatically switch to 
DMX mode when it sees the signal from a DMX controller. 
Note: In the absence of DMX signal, the fixture will automatically revert to standalone 
mode. Plugging in a DMX cable that is connected to a DMX controller will automatically 
disable standalone mode and put the fixture into DMX mode. 
1. 
Plug in your DMX controller to the fixture to put in into DMX mode. 
 
2. 
Set your address by 
SET.d.
 
 
3. Press 
Enter.
 
 
4. 
Use the Up and Down buttons to scroll to the desired DMX starting address.
 
 
5. Press 
Enter.
 
Vue™ 4.1 User Manual 
11 
7/11/2008 11:57 AM