Panasonic NV GS 330 Manuale Utente

Before using

VQT1L48

When quick start is ON the battery power is still
being consumed, even when the LCD monitor 
and the viewfinder are closed.
The movie camera will resume recording/pause 
mode about 1.7 seconds after the LCD monitor or 
the viewfinder is reopended.
≥Please note in quick start mode approximately 

half the pause recording power is being 
consumed. Using quick start mode will reduce 
the battery recording/playback time.

≥This is only activated in the following cases.

≥While using the battery

A tape or a card is inserted, while the Tape 
Recording Mode is set.
A card is inserted, while the Card Recording 
Mode is set.

≥While using the AC adaptor

quick start can be used even if a tape/card 
is not inserted.

≥Set to Tape/Card Recording Mode. 

≥The Status indicator lights green and the unit 

goes into quick start standby mode.

≥The movie camera will not go into quick start 

standby unless the LCD monitor is closed and 
the viewfinder is retracted.

≥The Status indicator lights red and the 

camera is put into recording pause approx. 
1.7 seconds after it is turned on.

ª

≥If the [OFF/ON] switch is set to [OFF] while the 

unit is in quick start standby, the power turns off.

≥If the standby continues for approx. 30 minutes, 

then the status indicator will go off and the 
camera will be completely turned off.

≥In the following cases, quick start is cancelled 

and the power turns off.

≥When the Mode dial is moved.
≥When the battery or AC adaptor is removed.
≥When both the tape and card are removed 

while using the battery in Tape Recording 
Mode.

≥When the card is removed while using the 

battery in Card Recording Mode.

≥When the camera is quick-started with the white 

balance on automatic, it may take some time 
until the white balance is adjusted if the scene 
being recorded has a light source different from 
the scene last recorded. (When the colour night 
view function is used, however, the white 
balance of the scene last recorded is retained.) 

≥If the power is turned on in quick start standby, 

the zoom magnification becomes 1

k and the 

picture size may differ from what it was before 
quick start standby.

≥If [POWER SAVE] (

) is set to [5 MINUTES] 

and the unit automatically goes into quick start 
standby mode, set the [OFF/ON] switch to 
[OFF], then to [ON] again. Also, close the LCD 
monitor and retract the viewfinder and then 
open the LCD monitor or extend the viewfinder 
again.

OFF

ON

OFF

ON

VQT1L48_ENG.book  14 ページ  ２００７年１２月１１日　火曜日　午後４時５５分