Panasonic VDR-D220GN Manuale Utente

Pagina di 108
Others
93
LSQT1161
The remote control does 
not function.
≥ Has the button-type battery of the remote control run out? 
# Replace it with a new button-type battery. (l 13) 
The DISC EJECT lever 
does not work.
≥ The disc cover will not open unless the unit is powered.
# Connect a charged battery or AC adaptor.
≥ The DISC EJECT lever does not work when the unit is 
connected to the computer. (VDR-D310) (Refer to the operating 
instructions for PC connection.)
The disc cannot be read.
≥ Are there fingerprints or dirt on the surface of the disc?
# If there are fingerprints or dirt on the disc, wipe them off. (l 20)
A function indication 
such as the remaining 
time indication or the 
elapsed time indication is 
not shown.
≥ If you set [SETUP]
>[DISPLAY]>[OFF], indications other than 
warnings and date indications disappear.
Recording does not start 
although power is 
supplied to this unit and 
the disc or card is 
correctly inserted.
≥ Is the DVD-RAM or the DVD-RW (VR format) write-protected?
# Release the protection. (l 74) If the DVD-RAM or DVD-RW (VR 
format) was protected on another device, release the protection 
on the same device.
≥ Has the DVD-RW (Video format) or DVD-R been finalized?
# After finalizing, the discs become play-only and cannot record. If 
you un-finalize a DVD-RW (Video format), it can be used for 
recording. (l 74)
≥ Has the SD card’s write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set to 
LOCK. (l 19)
≥ Is the memory of the disc or card full?
# If the disc or card has no more available memory, free up some 
memory by deleting unnecessary scenes (l 63, 70) or use a 
new disc or card.
≥ Is the unit set to the video recording mode or picture recording 
mode?
# No recording is possible unless the mode dial is at 
 or 
.
≥ Is the disc cover open?
# If the cover is open, this unit may not operate normally. Close the 
disc cover.
Recording starts but 
stops immediately.
The playback picture 
breaks up for a moment.
≥ Is the disc scratched or dirty?
# Clean the disc. (l 20) If there are scratches on the disc, use a 
new disc.
≥ The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a while.
The unit arbitrarily stops 
recording.
≥ Is the AGS function activated? 
# Record in the normal horizontal position or set [AGS] to [OFF]. 
(l 38) 
Problem
Check points
LSQT1161_GN.book  93 ページ  2007年1月19日 金曜日 午後1時8分