Panasonic HDC-DX1 Manuale Utente

Pagina di 128
28
VQT1A15
Setup
≥The batteries heat up after use or charging. 
This unit will also heat up while being used. 
This is not a malfunction.
≥Be aware that the operating time of the battery 
will become shorter in low temperatures. We 
recommend charging a spare battery for use 
when recording.
ª About the remaining battery 
capacity indication
The remaining battery capacity is displayed in 
minutes when using the Panasonic battery that 
you can use for this unit. It may take time to 
display the remaining battery capacity.
≥The display changes as the battery capacity 
reduces. 
#
#
#
#
.
If there are less than 3 minutes, then 
 
will become red. If the battery discharges, then 
 
will flash.
≥The remaining battery capacity may not be 
displayed correctly where the temperature is 
low or high or if the battery was not used for a 
long period of time.
To correctly display the remaining battery 
capacity, recharge the battery, discharge it and 
then charge it again. (Even if this operation is 
performed, it may not be possible to display the 
remaining battery capacity correctly if the 
battery was used for a long period of time 
where the temperature is low or high or if the 
battery was repeatedly charged.)
≥The maximum amount of remaining battery 
capacity able to be indicated is 240 minutes. If 
the actual remaining time exceeds 
240 minutes, the indication will stay green and 
will not change until the remaining time falls 
below 240 minutes. 
≥Depending on the conditions of use, the time 
displayed on the remaining battery capacity 
indication will change so use it as an 
approximation.
≥When turning the mode dial to switch modes, 
the time indication will turn off in order to 
recalculate the remaining battery capacity time.
≥When using batteries made by other 
companies the remaining battery capacity will 
not be shown. 
Connecting to the AC outlet
The unit is in the standby condition when the AC 
adaptor is connected. The primary circuit is 
always “live” as long as the AC adaptor is 
connected to an electrical outlet.
1
Connect the AC cable to the AC 
adaptor and the AC outlet.
2
Connect the DC cable to the AC 
adaptor.
3
Connect the DC cable to the DC 
input terminal DC IN 7.3V.
≥Do not use the AC cable with any other 
equipment as it is designed only for this 
unit. Do not use the AC cable from other 
equipment with this unit.
≥While the DC cable is connected to the AC 
adaptor, the battery will not charge.
90min
VQT1A15ENG.book  28 ページ  2007年1月29日 月曜日 午後8時24分