Panasonic AG-DVC60 E Manuale Utente

g Listening to sound that has been 

You can switch between the sound that has been 
dubbed and the sound heard during shooting using 
the 32K (12bit) AUDIO item setting on the PLAY-
BACK FUNCTION screen. 

The sound heard during shooting is played back.

The sound that has been dubbed on a recording 
is played back.

Both the sound heard during shooting and that 
you have dubbed on a recording are played back 
at the same time.

g Performing audio dubbing as you 

You can monitor the sound by setting “ST2” while 
audio dubbing is temporarily suspended.
If you use headphones when performing audio dub-
bing on a recording using mic input, you can listen 
to the sound being dubbed.
When you perform audio dubbing using line input 
(from the audio component connected to the 
AUDIO IN/OUT jack), you can listen to the sound 
being dubbed through the speakers.

g Using the counter memory func-

First reset the counter memory display at the 
position where the audio dubbing is to end. 
(P48)
Rewind the tape to the position where the audio 
dubbing is to start, and start the dubbing.
The tape then stops automatically at the position 
on the tape where the counter memory display 
was reset.

g Adjusting the audio input level

Use the procedure described for “Adjusting the mic 
input audio level” 

(P42) to adjust the audio level of 

mic input.

• You cannot adjust the level of  A_IN input.

g Adjusting the audio output level

Use the procedure described for “Adjusting the 
headphone volume” 

(P42) to adjust the audio level 

output from the headphones and speakers.

1

2

3

Note
In the LP mode, you cannot dub after recording as the 
track on the tape is thinner than the head.

AG-DVC60E_En.fm  53 ページ  ２００４年９月２日　木曜日　午後１時４３分