Panasonic PV-DV20 Manuale Utente
7
Getting
Star
ted
Getting
Star
ted
1
Slide Light into the Built-in Light
Mount.
Be sure it locks into place.
Mount.
Be sure it locks into place.
2
Press LIGHT to turn
ON or OFF.
ON or OFF.
Before Using
Before Using
1
Slide TAPE EJECT to open the
Cassette Compartment Cover.
Cassette Compartment Cover.
2
Insert a cassette record tab up,
window side facing out.
window side facing out.
3
Press PUSH TO CLOSE mark to
close the Cassette Compartment
Cover.
close the Cassette Compartment
Cover.
1
TAPE EJECT
Switch
Cassette Compartment Cover
3
PUSH TO
CLOSE mark
Note
• If hand strap is tight it may prevent Cassette Compartment Cover from fully opening
for tape insertion or ejection. Loosen hand strap if necessary.
• When inserting the cassette, make sure it faces in the right direction and then push in
completely.
Cassette Insertion/Removal
Before you begin
• Connect the Palmcorder to a power
source. (See pages 11, 12.)
To brighten the natural colors in a scene.
Using the Light (Optional)
Before you begin
• Connect the Palmcorder to a power
source. (See pages 11, 12.)
• Set POWER to CAMERA or M-CARD.
• If the Palmcorder is connected to a power
source, the cassette can be inserted and
ejected without turning the Palmcorder
on.
ejected without turning the Palmcorder
on.
• To remove the cassette...
Slide TAPE EJECT to open the Cassette
Compartment Cover and pull the cassette
tape straight out.
Compartment Cover and pull the cassette
tape straight out.
Hint to locate recording position when inserting cassette
• When you insert a partially recorded cassette, use the Edit Search Function (see page
• When you insert a partially recorded cassette, use the Edit Search Function (see page
24) to visually confirm the point at which you want to start a new recording. Especially
advisable when you want to add a recording to a tape that is already full.
advisable when you want to add a recording to a tape that is already full.
2
LIGHT Button
LIGHT RELEASE Button
Built-in Light Mount
Caution
This light becomes hot during operation.
Make sure nothing covers the Light
during operation.
Make sure nothing covers the Light
during operation.
• Using the light will reduce battery
operating time.
• Be sure to provide
adequate ventilation if using Light in a
hot environment for an extended period.
hot environment for an extended period.
• Be sure LIGHT is set to OFF when not in
use.
• Do not attempt to lift or carry the
Palmcorder by holding the Enhancement
Light.
Light.
• If light bulb needs to be replaced, take
Light to your nearest authorized
servicenter.
servicenter.
Note
To remove the Light:
Press LIGHT RELEASE and slide the
Light out of the mount.
Light out of the mount.
201_401. 5-8.p65
01/01/18, 17:07
7