Samsung SCD457 Manuale Utente

Pagina di 119
ENGLISH
ESPAÑOL
114
114
Troubleshooting
Solución de problemas
Condensación de humedad
Antes de ponerse en contacto con un centro de servicio autorizado
de Samsung, realice las siguientes comprobaciones.
Es posible que le ahorren el tiempo y el coste de una llamada
innecesaria.
✤ Si se lleva la videocámara directamente de un lugar frío a uno cálido, se
puede condensar la humedad dentro de ella, en la superficie de la cinta o en
el objetivo. En estas condiciones, la cinta puede adherirse a los cabezales y
estropearse o puede que el aparato no funcione correctamente.
Para prevenir posibles daños bajo estas circunstancias, la videocámara está
dotada con un sensor de humedad.
✤ Si hay humedad dentro de la videocámara, aparecerá en la pantalla la señal
(DEW).
Si esto sucede, ninguna de las funciones de la videocámara estará operativa,
excepto la de expulsión de la cinta.
Abra el compartimento del casete y quite la batería.
Deje la videocámara durante al menos dos horas en un lugar seco y
templado.
Solución de problemas
Pantalla de autodiagnósticos
Lento
Lento
no
Lento
Lento
Lento
Lento
la batería está casi descargada.
Reemplácela por una cargada.
el tiempo restante de grabación es de unos
dos minutos.
Prepare una cinta nueva.
la cinta ha llegado al final.
Cámbiela por una nueva.
no hay cinta en la videocámara.
Introduzca una cinta.
la cinta está protegida contra grabación.
Si desea grabar, libere la protección.
se ha condensado humedad en la
videocámara.
Ver más abajo.
la videocámara tiene algún fallo mecánico.
1. Saque la cinta.
2. Apague la videocámara.
3. Quite la batería.
4. Ponga de nuevo la batería.
* Si no puede resolver el problema,
póngase en contacto con el centro
de servicio de SAMSUNG.
Pantalla
Parpadeo
Indica que...
Solución
Tape end !
(Fin de cinta !)
Tape end !
(Fin de cinta !)
No Tape ! (No
hay cinta !)
Protection !
(Protección !)
....D
L
C
R
Moisture Condensation
Self Diagnosis Display
Before contacting a Samsung authorized service center, perform
the following simple checks.
They may save you the time and expense of an unnecessary call.
If the Camcorder is brought directly from a cold place to a warm
place, moisture may condense inside the Camcorder,
on the surface of the tape, or on the lens. In this condition, the tape
may stick to the drum head and be damaged or the unit may not
operate correctly.
The Camcorder is fitted with a moisture sensor to resist damage
under these circumstances.
If there is moisture inside the Camcorder, 
(DEW) is displayed.
If this happens, none of the functions except cassette ejection will
work.
Open the cassette compartment and remove the battery.
Leave the Camcorder in a dry, warm room for at least two hours.
slow
slow
no
slow
slow
slow
slow
the Battery pack is almost discharged. Change to a charged one.
When the remaining time on the tape
about 2 minutes. 
Prepare a new one.
the tape reached its end.
Change to a new one.
there is no tape in Camcorder.
Insert a tape.
the tape is protected from recording.
If you want to record, release
the protection.
moisture condensation has formed in
the Camcorder.
see below.
the Camcorder has some mechanical
fault.
1. Eject the tape.
2. Set to OFF.
3. Detach the battery.
4. Reattach the battery.
* If unresolved contact your local
Samsung service center.
Tape end !
Tape end !
No Tape !
Protection !
....D
L
C
R
Display
Blinking
Informs that... 
Action
Troubleshooting
00840E SCD451 USA+ESP~118  3/22/05 12:03 PM  Page 114