TE Connectivity LAN Cat.6 S/FTP 1-0959385-1 Manuale Utente
Codici prodotto
1-0959385-1
108-93010
Rev E
2 of 5
INGF-070
3.
REQUIREMENTS
3.1
Design and Construction
Product shall be of design, construction and physical dimensions specified on applicable customer drawing.
3.2
Standard length
Applicable standard lengths: from 0.5meter to 20meter (both included).
For other lengths, put in contact with your sales representative.
3.3
Materials
Materials shall be in accordance to Tyco Electronics requirements about environmental-related substances as
per Tyco Electronics specification 230-702.
The material of the cable jacket is identified on the customer drawing and shall comply with the standards
mentioned in Product Specification 108-93018 Copper LAN cable.
3.4
Ratings
Operating Temperature:
-20 to 60ºC
3.5
Packaging
Each assembly shall be supplied in a clear bag.
3.6
3.6
Bending radius
The minimum bending radius is 8x outside diameter during installation and 4x the outside diameter after
installation.
3.7
Performance requirements and test procedures
Product is designed to meet electrical, mechanical and environmental performance requirements specified in
Figure 1. Unless otherwise specified, all tests shall be performed at ambient environmental conditions.
Test Description
Requirement
Test Procedure
VISUAL
Examination
of
product.
Meets requirements of product drawing. Visual inspection criteria as defined in IEC
61935-2, Paragraph 5.1.
ELECTRICAL
Wire map
Continuity and short circuit
Wire map configuration as per TIA 568B
Wire map configuration as per TIA 568B
Any device which ensures quality
Shield continuity
Shield continuity
Any device which ensures quality
AMPTRAC connection
(9
(9
th
wire)
(only for AMPTRAC versions)
Continuity and short circuit (between
pogo pin and plug shield)
pogo pin and plug shield)
Any device which ensures quality.
(See figure 2 as information)
(See figure 2 as information)
Voltage proof
(only for AMPTRAC versions)
1 minute hold with no breakdown or
flashover
flashover
IEC 60512-4-1
1500 volts AC peak voltage to be applied
between pogo pin and plug shield.
Maximum leakage current 5 mA
between pogo pin and plug shield.
Maximum leakage current 5 mA