Hitachi DZ-HS500A Manuale Utente

English

Press the MENU button, use the f/e/
d/c buttons to choose “White Bal.” on the 
“Camera Functions Setup” menu screen, and 
then press the A button.

Choose the desired option, and then press the 
A button.

Press the MENU button to end the setting.

• The white balance mode can be confirmed using the 

on-screen information.

• The white balance setting will be stored in memory 

even when the DVD video camera/recorder is turned 
off.

• Do not block the infrared sensor with hand, etc.

• If a tele or wide-conversion lens is used, the auto 

white balance may not operate depending on the 
recording conditions. If this happens, set to the mode 
to match the recording conditions, or manually set the 
white balance.

• Be sure to remove the lens cap before turning the 

DVD video camera/recorder on: If the DVD video 
camera/recorder is turned on with the lens capped, 
the white balance will not work normally.

●Setting white balance manually

Point the DVD 
video camera/
recorder at a white 
object so that it fills 
the screen. Use an 
object that is not 
transparent.
If focus is not 
correct when the 
white object fills the screen, manually focus 
the object, referring to “Manually Focusing 
Subject” (see page 53).

Press the MENU button, use the f/e/
d/c buttons to choose “White Bal.”, “Set” 
on the “Camera Functions Setup” menu 
screen, and then press the A button.

Hold A button pressed until the “h” 
indicator changes from blinking to a steady 
light. When the “h” indicator lights, the 
white balance setting will be complete.

Press the C button to end the setting.

• The white balance set using the “Set” option will be 

stored in memory until it is re-set.

• Do not use a colored object when setting the white 

balance: The appropriate tint cannot be set.

• If “Input Source: LINE” has been specified, you 

cannot use the “Set” mode of white balance (p. 64) .

• The setting on white balance “Set” may not be 

possible in a dark place. Also, the white balance 
cannot be set when the zoom bar is in the digital 
zoom range (p. 51). In such status, the “h” indicator 
will remain blinking. Set the white balance in a bright 
place with “Dig. Zoom: Off” specified.

• If the recording conditions have changed, re-set the 

white balance for appropriate colors.

• The setting will be stored in memory even when the 

DVD video camera/recorder is turned off: The “h” 
indicator will blink when the DVD video camera/
recorder is turned on next time. Re-set the white 
balance as needed.

Infrared sensor block

Thick paper