Home Automation 20A00-1 Manuale Utente

Page 44

To enable or change a thermostat type, press the ' # ' key. Use the arrow keys to scroll through the list of thermostat types, then
press ' # ' to select a new type

The display shows:

SELECT TYPE: 1

AUTO HEAT/COOL

↓

TYPE NUMBER

DESCRIPTION

AUTO HEAT/COOL

Automatic changeover heat and cool thermostat

HEAT/COOL

Manual changeover heat and cool thermostat

HEAT

ONLY

3 Heating

only

thermostat

COOL

ONLY

4 Cooling

only

thermostat

SETPOINT ONLY

Setpoint only thermostat

SETUP MISCELLANEOUS

To configure the miscellaneous Installer Setup items, from the Installer Setup menu, press the 6 (MISC) key.

INSTALLER CODE

The Installer code allows the installer access to the Installer Setup menu. The Installer code should be changed and not given to
the customer. The Installer code cannot be used for remote phone access.

INSTALLER

CODE:

0000-9999

0000=DISABLE

↓

The default setting for the Installer code is 1 1 1 1.

NOTE:

Remember this Installer code and do not disable. There is no way to reset or retrieve the code! If the code is forgotten or
disabled, the Omni II controller must be sent back to the factory. Call for an RA#.

ENABLE PC ACCESS

This enables or disables the PC ACCESS feature. Factory default is enabled.

ENABLE PC ACCESS: 1

0=NO 1=YES

↕

PC ACCESS CODE

This code allows dealers to put an access code in the system that is separate from the customer's Master code and the Installer
code. Dealers can use the PC Access code to access the system by PC. The PC Access code cannot arm and disarm the system.
The PC Access code is NOT programmed from the factory. To use it, set it to any code other than 0000. To disable the PC
Access code, enter 0000 for the code.

NOTE: This item must be enabled (by entering a code) if PC Access is will be used.

PC ACCESS CODE:

0000-9999

0000=DISABLE

↕