GE 1000 Manuale Utente

One of the biggest concerns you might have regarding your security system, is causing 
an accidental alarm. Most accidental alarms occur when leaving the residence after 
arming the system, or, before disarming the system upon your return.

There is a communicator delay (Dialer Delay) of 30 seconds programmed into this 
panel. The panel will delay 30 seconds before dialing the central monitoring station or a 
numeric pager to send reports. You can have your installer program this delay time 
between 0 - 254 seconds. 

You have ___ seconds to cancel an accidental alarm.

To cancel an accidental alarm before the programmed dialer delay time expires, enter 
your access code.

The following guidelines will go a long way toward preventing accidental alarms.

•

Close doors and windows before you leave your house.

•

Gather your belongings, so you can exit immediately after arming the system.

•

Always enter and exit within the programmed delay times.

•

Make sure you leave through a door that has a delay time set for it.

•

Disarm your system immediately upon returning home.

•

Be aware of the devices in your security system and learn how each one operates.

•

If you have pets, ask your installer if you need pet lenses in your motion detectors.

•

Check the location of your smoke detectors. Smoke detectors near bathrooms and 
kitchens can be tripped by steam and smoke from cooking.

•

Take note of system beeps, voice announcements and indicator lights which indi-
cate the current system status.

You may use an off-site phone to arm/disarm your panel, turn lights on and off, check 
system status, or conduct an audio session (ask your installer if you have this feature).

¾

1.

Call the panel and let the phone ring twice then hang up.

2.

Wait at least 10 seconds and call the panel again. You may wait up to 40 seconds 

before calling again.

3.

The panel should answer on the first ring. You won’t hear any prompt when the 

system answers.

4.

Press the * button on your telephone and you will hear system activated.

At this point you may perform the actions listed in the following table of phone com-
mands. CODE refers to the master and access codes programmed into your system.

DISARM

‚ + CODE + 1

ARM Doors/Windows

‚ + CODE + 2

ARM Doors/Windows with No Entry Delay

‚ + CODE + 2 + 2

ARM Motions

‚ + CODE + 3

ARM Motions with Latchkey

‚ + CODE + 3 + 3

ARM Doors/Windows and Motions

‚ + CODE + 2 + 3