Phonetics 5100 Manuale Utente

Sensaphone

®

 ISACC Instruction Manual

ISACC should be mounted and operated in a clean, dry environment.  If this is not possible,
NEMA 4 conduit hubs should be installed to seal ISACC off from the hazardous environment.
The temperature range that ISACC can operate in is 32

°F to 120°F (0°C to 49°C).

When you receive ISACC, there will be a PC Board (ISACC) mounted inside an ABS plastic
enclosure rated at NEMA 4, 4X, 12 and 13.  You will also find the ISACC Instruction Manual,
a Communication Hookup Kit and ISACC Communication Software.

Carefully remove ISACC from the box.  The mounting holes are located under the six plastic
screws.  Carefully remove them and the clear top cover to mount the enclosure.  Decide where
you will be mounting ISACC and drill holes according to the diagram below.

strain relief clamp

phone receptacle

RS232 port

power cord

10"

10.5"

10.5"

PC board (ISACC)

enclosure

mounting holes under 
plastic screws

.27" diameter

Mounting ISACC enclosure

After the holes have been drilled, you can mount the enclosure.  Reinstall the top cover after
installation is complete.

Strain relief clamps are provided in the ISACC enclosure to prevent wiring from being pulled
from the circuit board or damaged when passing through the enclosure.  To use the strain
relief, thread wires through the clamp and clear rubber bushing.  Position the bushing in the
clamp and tighten the screws on either side so that the wiring does not move.