Phonetics 5100 Manuale Utente
55
Chapter 7: Programming
Online time out
- When you are online with ISACC locally or remotely, the unit looks for
inactivity. This parameter allows you to set the amount of time, 1 - 255 minutes, that ISACC
will wait during inactivity before it terminates the online session, the default is 4 minutes. If
there is inactivity that meets this parameter, ISACC will disconnect and display the message
TIME OUT on your screen.
will wait during inactivity before it terminates the online session, the default is 4 minutes. If
there is inactivity that meets this parameter, ISACC will disconnect and display the message
TIME OUT on your screen.
Acknowledge on carrier
- When ISACC dials out in data mode, the unit will wait to
receive a carrier signal from a modem. This tells ISACC that a telephone connection has been
made. The acknowledge on carrier parameter allows you to program ISACC to self-acknowl-
edge an alarm when it receives the carrier signal. To acknowledge on carrier, type Y for yes. If
you do not want ISACC to acknowledge on carrier, type N for no. The default is Yes.
made. The acknowledge on carrier parameter allows you to program ISACC to self-acknowl-
edge an alarm when it receives the carrier signal. To acknowledge on carrier, type Y for yes. If
you do not want ISACC to acknowledge on carrier, type N for no. The default is Yes.
When used with the SHOW command, the SYSTEM keyword also displays the following
information in addition to the current values of the above parameters:
information in addition to the current values of the above parameters:
Alarm acknowledgment status
- This parameter tells you if any alarms exist and, if so,
whether they have been acknowledged or not. To see which inputs are in alarm, type SHOW
ALARMS.
ALARMS.
C program run status
- This parameter will indicate if there is a C program running or not.
Data log status
- This line will indicate if the data logger is currently running.
Current temperature
- ISACC has a temperature sensor on its circuit board. This parameter
will display the current board temperature, not air temperature, in degrees Fahrenheit and
degrees Celsius.
degrees Celsius.
Battery level
- This parameter displays the present voltage of the backup battery, rounded to
the nearest whole number.
AC power status
- This parameter displays the status of the AC power. NOTE: You may use
power outage as a system alarm by controlling it through a C program. See Chapter 8.
To display the current system information and global parameter values, type show system at
an ISACC prompt:
an ISACC prompt:
ISACC>show system
SYSTEM INFORMATION
No unacknowledged alarms exist
C program not running
Data logger not running
The temperature is 78 Deg F, 25 Deg C
Battery level is 21 V
AC power is OFF
Unit identification = Snow
Phone number of unit = 555-4592
Data password = 23B79Q4
Network node = 1
Rings until answer = 3
Phone dialing (0=pulse, 1=tone) = 1
Time between calls = 0 Min 30 Sec
Wait time between rounds = 5 Min
Maximum number of calls = 3