Phonetics 5100 Manuale Utente

Sensaphone

ISACC Instruction Manual

ALARMS

The keyword command SHOW ALARMS will display the present status of the inputs in
alarm, if any alarms exist. The prefix SET is not valid with this keyword.

To display the current input alarm status, type show alarms at an ISACC prompt:

ISACC>show alarms

DIALOUT ALARM STATUS

No alarms

DIALOUT

This command allows you to enable or disable an input’s ability to cause a dialout during an
alarm on that input. If the input is enabled, an alarm on that input will initiate a dialout. If
the input is disabled, ISACC will not dialout if an alarm occurs on that input.

To display the input dialout programming, type show dialout after an ISACC prompt. You
may also display the dialout programming for a specific input by typing show dialout followed
by the input number.

ISACC>show dialout

DIALOUT ENABLING

IN01 = "LOW WELL FLOAT " = Yes

IN02 = "HI SUMP FLOAT " = Yes

IN03 = "Input #3 " = Yes

IN04 = "FLOW RATE (GPM) " = Yes

IN05 = "WELL LEVEL (FT) " = Yes

IN06 = "RESET " = Yes

IN07 = "Input #7 " = Yes

IN08 = "VOLTAGE " = Yes

IN09 = "Input #9 " = Yes

IN10 = "Input #10 " = Yes

IN11 = "Input #11 " = Yes

IN12 = "Input #12 " = Yes

IN13 = "Input #13 " = Yes

IN14 = "Input #14 " = Yes

IN15 = "Input #15 " = Yes

IN16 = "Input #16 " = Yes

To program the dialout for an input, type set dialout after ISACC prompt. To enable the
input for dialout, type Y after prompt. To disable the input for dialout, type N at the prompt.
You may also program the dialout for a specific input by typing set dialout followed by the
input number.

ISACC>set dialout

DIALOUT ENABLING

IN01 = "LOW WELL FLOAT " = Yes (Y or N) >

IN02 = "HI SUMP FLOAT " = Yes (Y or N) >

IN03 = "Input #3 " = Yes (Y or N) >N

IN04 = "FLOW RATE (GPM) " = Yes (Y or N) >

IN05 = "WELL LEVEL (FT) " = Yes (Y or N) >

IN06 = "RESET " = Yes (Y or N) >

IN07 = "Input #7 " = Yes (Y or N) >N

IN08 = "VOLTAGE " = Yes (Y or N) >

IN09 = "Input #9 " = Yes (Y or N) >N