AT&T 8300 Manuale Utente

Your AT&T Security System 8300 requires very
little maintenance. All you will normally need to do
is keep the components clean and replace any
batteries that run low. Many dealers offer annual
maintenance checks, and they will replace any
batteries that are running low. If you need to
change a battery yourself, follow the directions
below to put your system in the Test mode and
then turn to the Optional Components section for
that component for further directions.

Wipe the outside of system devices every six

months (more often in dusty or dirty areas). Use a
cloth that has been slightly moistened in a solution
of mild detergent. You can also use a vacuum to
remove dust, but do not use a vacuum on smoke

detectors. Do not disconnect components,
submerge them in liquid, or use any cleaning
sprays on them.

Perform the following test procedure, every week,

to ensure that your system is working properly.

Begin at the Status Menu, under normal condi-

tions, with the Level of Protection set to  Off.

Press NEXT to go to the Main Menu.
Select SECURITY and enter your Level 1
access code.
The following screen will appear with CODES
flashing:

Select TEST.

The following screen will appear, with LIST
flashing:

Select LIST. The display will show NOTHING
IN LIST. Your system is now in the Test mode.
No alarms will be generated by violated sensors.

The system will return to the 

Off level

 of protec-

tion after any 10 minute period of inactivity.

Put your system in the Test Mode.

When your display shows NOTHING IN LIST,

move through the premises activating each

sensor (open doors, walk in front of PIRTs,  push
the buttons on your smoke detectors and

universal transmitters, etc.). As the system
detects each activation, the Display Control
Keypad beeps.

NOTE: Some sensors are grouped into zones.
You must activate every sensor in a zone to
verify all sensors. Your dealer should inform
you of any zone configurations in your system.

Return to the keypad. The last sensor you

activated will be listed in the display. Select. 

 

to go backwards through the list. There may be
violations that occurred inadvertently and some
violations may repeat themselves. After you

have confirmed all the violations select 

   

 if

you wish to view the list again, >> to return to
the Status Menu, or < to return to the previous

Menu.

NOTE: You cannot leave your system in the

Test mode. After 10 minutes of inactivity, the

system will return to the 

 level of protection.

1 Put your system in the Test mode.

2 Simultaneously, press both POLICE buttons or

both EMERGENCY buttons.

3 After you hear the alarm, cancel it by entering

your access code and pressing OFF.

Contact your monitoring service and notify them
that you are going to send a test message.
There may be a charge for this service.

Begin at the Status Menu, under normal condi-

tions, with the system set to Off.

Press NEXT to go to the Main Menu.
Select SECURITY and enter your Level 1

access code.
The following menu will appear with CODES
flashing:

I 

Select TEST.

22