Avaya 03-300430 Manuale Utente
FW-DWNLD (Firmware Download)
Issue 1 June 2005
1307
7
FAIL
The source board entered on the screen is not present.
1. Execute the display firmware download command, and verify
the source board’s location.
2. Verify the source board’s translations.
3. If the location is incorrect, execute the change firmware download
command, and enter the correct location on the screen.
8
FAIL
The source boards entered on the screen are incorrect. The board could
have been changed after the schedule was entered.
have been changed after the schedule was entered.
1. Execute the list configuration command. Verify the source
board’s location.
2. Execute the change firmware download command, and enter the
correct location on the screen.
PASS
Firmware download to this circuit pack is successful.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Ensure that the board’s translations are correct.
2. If the board was already administered correctly, check the error log to
determine whether the board is hyperactive.
If so, the board was shut down. Reseat the board to reinitialize it.
3. If the board was found to be correctly inserted in step 1, then:
a. Enter the busyout board location command.
b. Enter the reset board location command.
b. Enter the reset board location command.
c. Enter the release board location command.
d. Enter the test board location long command.
This should re-establish the linkage between the internal ID and the
port.
This should re-establish the linkage between the internal ID and the
port.
Table 450: TEST #1413 Firmware Download Test (continued)
Error
Code
Code
Test
Result
Result
Description / Recommendation
3 of 3