Avaya 03-300430 Manuale Utente

1003

ABRT

The system could not allocate a tone receiver for the test.  The system may 
be oversized for the number of Tone Detectors present or some Tone 
Detectors may be out-of-service.

1. Resolve any TTR-LEV errors in the Error Log.

2. Resolve any TONE-PT errors in the Error Log.

3. If neither condition exists, retry the command at 1-minute intervals up to 

5 times.

4. If the test continues to abort, escalate the problem.

1004

ABRT

A valid call seized the port during the test and aborted the test.

1. Use display port location to determine the station extension.
2. Use status station extension to determine the service state of 

the port.

3. If the port is active, wait until it is idle before testing.  Retry the 

command at 1-minute intervals up to 5 times.

4. If the test continues to abort, escalate the problem.

1005

ABRT

This test was aborted due to a configuration problem.  The test is not 

applicable for this type of analog port.  This error can be ignored.

1018

ABRT

Administration has disabled the test.  The default for the Test field on the 
station screen is y.  Determine why this field has been set to n on this 
station (this may be due to the ringing application Test 48, which can be 
disturbing to customer or terminal equipment).

1. To enable the test for a particular station being tested, enter change 

station extension.

2. Enter y in the Test field.

 

1412

ABRT

This test does not execute on a G700 Media Gateway.

 2 of 4