Chauvet SCAN LED 300 Manuale Utente

 
4. Operating Instructions 

10 

10/25/2010 10:23 AM  

 

 

 

 

 

This is the operating mode which will allow for control with an external DMX controller. You must 
set the starting address for this mode. If this is your first time using DMX, then it is recommended 
that you refer to the “DMX Primer” section in the “Appendix” of this manual. 
 

1. Press 

<MODE/ESC> until 

 appears on the LED screen.

 

2. Using 

<UP> and <DOWN>, select the starting address (001~512).

 

3. Press 

< ENTER > until one of the DMX personalities appears on the LED screen (

).

 

4. Using 

<UP> and <DOWN>, select the desired DMX personality.

 

5. Press 

<ENTER>.

 

 

 

 

 

 

This mode allows a single unit, the master, to operate in one of the standalone modes, while one 

or more fixtures, slaves, synchronize their responses to the master. 

Master: 

The master fixture may be set in any of the STANDALONE modes: sound-active, fast, or 
slow. 

Slave: 

1. Press 

<MENU> until 

 appears on the LED screen.

 

2. Press 

< ENTER >.

 

 

 

 

 

 

This fixture has a preprogrammed chase that will operate in a preprogrammed, slow playback 
speed. 
 
Access this mode via the control panel on the front of the fixture. Please see the instructions 
below for further explanation. 
 

1. Press 

<MODE/ESC> until one of the standalone modes appears on the LED screen 

(

).

 

2. Using 

<UP> and <DOWN>, select 

.

 

3. Press 

<ENTER>.

 

 

 

 

 

 

This fixture has a preprogrammed chase that will operate in a preprogrammed, fast playback 
speed. 
 
Access this mode via the control panel on the front of the fixture. Please see the instructions 
below for further explanation. 
 

1. Press 

<MODE/ESC> until one of the standalone modes appears on the LED screen 

(

).

 

2. Using 

<UP> and <DOWN>, select 

.

 

3. Press 

<ENTER>.