Liebert 50 & 60Hz Manuale Utente

If the evaporator and condensing units are to be mounted side-to-side (close coupled), hang each unit 

before connecting them together (See Figure 5). If Single Point Power Kit is used, install the box into the 

evaporator prior to suspending the units. Route power wire flex conduit into condensing unit as units are 

suspended. Refer to instructions supplied with kit for details. Align bolt holes in the condensing unit and 

in the evaporator. Insert rubber spacers and secure four (4) sets of hardware provided. Align the refriger-

ant connections and tighten them as described in 2.4.3 - Piping Connections and Coolant Require-

ments. Remove “P” clamps from piping to aid fitting alignment.