Hunter Fan 31018 Dépliant

Failure to ensure the tank is seated correctly could cause 

the unit to leak water from the tank. 

6.  Insert the power adapter into the 

bottom right side of the unit, then plug 

the adapter into a wall outlet.

Model

•  ALWAYS place the humidifier in an area that is out of the 

reach of children.

•  Before using the humidifier, extend the cord and inspect 

for any signs of damage. DO NOT use the product if the 

cord has been damaged.

•  ALWAYS UNPLUG AND EMPTY the humidifier when it is 

not in operation or while it is being cleaned.

•  Do not use water bottles greater than 22 oz.

•  This product is intended for residential use only. DO 

NOT use outdoors.

•  This device complies with part 18 of the FCC Rules.

Form# 44125-01   

 

 

    20120628 

©2012 Hunter Fan Co.

Transducer

Power Shut-off Float

Fan Exhaust

Bottle Cap

Power Adapter

Humidity Adjustment Knob

Mist Exhaust

Power Plug

Reservoir 

Cover

1.  Unravel and straighten the cord before use.
2.  Set the unit on a flat, waterproof surface.
3.  Drop one demineralization tablet into your water bottle.  

(note: The tablet will remove minerals from the water to 

prevent dust accumulation. The benefits of each tablet 

will last up to one week between humidifier cleanings.)

4.  Use the water cap that came with your 

humidifier and press it down over the 

mouth of your water bottle firmly.

5.  Turn your water bottle upside down 

and insert into the water reservoir.

Operation:
To turn the humidifier on, turn the humidity 

adjustment knob clockwise until you feel the 

knob click. At this time the unit should be 

on and you can adjust the amount of mist 

the unit outputs by continuing to turn the knob clockwise. To 

turn the unit off, turn the humidity adjustment knob counter-

clockwise until it clicks.

1.  Turn off the humidifier and unplug the power adapter 

from the wall and the unit.

2.  Remove the water bottle from the unit and remove 

the cap.

3.  Empty the water from the bottle.
4.  Rinse the humidifier cap thoroughly with warm water. 

Replace the water bottle if necessary.

5.  Remove the reservoir cover from the humidifier and 

empty any remaining water.

6.  Wipe any mineral deposits from the cover and base 

with a soft cloth.

7.  Replace the cover onto the base. Align 

the notch on the cover with the groove 

on the base. The mist exhaust should 

be 45

°

 to the right of the humidity 

adjustment knob.