Heath Zenith 6280 Series Manuale Utente
-
+
-
+
-
+
Type
“D”
Type
“D”
Type
“D”
© 2008 HeathCo LLC
595-5506-12
This package includes (Style of push button and chime may vary from illustration):
• Wireless chime
• Wireless push button with battery (Specific models include 2)
• Hardware pack
This chime requires 3 “D” alkaline batteries (not included). In typical use,
alkaline batteries will last up to three years.
• Wireless chime
• Wireless push button with battery (Specific models include 2)
• Hardware pack
This chime requires 3 “D” alkaline batteries (not included). In typical use,
alkaline batteries will last up to three years.
6180 Series, 6270 Series,
and 6280 Series
and 6280 Series
Decorative Wireless
Chime
Cover Mounting Tabs
Chime
Volume
Jumpers
Figure 1
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screw-
driver (see Figure 1). See diagram inside push
button for correct battery orientation. Note: If
batteries are preinstalled, remove orange
battery tab.
pushing in tab on bottom with a small screw-
driver (see Figure 1). See diagram inside push
button for correct battery orientation. Note: If
batteries are preinstalled, remove orange
battery tab.
2. Install 3 alkaline “D” batteries. Make sure
batteries are oriented properly (see Figure 2).
3. Test range. Temporarily position chime and
push button where you want it mounted.
Press push button to verify chime and push
button work properly. If chime does not
sound, see Troubleshooting.
Press push button to verify chime and push
button work properly. If chime does not
sound, see Troubleshooting.
4. Adjust volume control. Adjust volume control
to desired volume (see Figure 2).
Figure 2