FIELD CONTROLS 24v Manuale Utente

UV-AIRE

Air Purification System

Installation Options

Installation

ALWAYS wear protective goggles to shield your eyes from UV
damage when installing the UV-Aire.

UV-C can break down plastic material that is not UV
resistant. Based on lab tests, positioning the lamp 30 inches
or more away from plastic surfaces such as flex duct, drain
pans, etc. will prevent any measurable break down.

1. Insert the unit downstream from an A-coil in the

supply plenum or downstream from the air filter in
the return plenum.
Mount base on duct
using the enclosed
mounting screws.

2. Insert lamp through

hole. Place bracket
over end of tube and
tighten wing nut.

3. Replace cover on unit

and tighten
side screw.

4. Plug into 120V outlet

& place rocker switch in “ON” position.

5. Switch will illuminate & blue glow can be seen

through view port when unit is operating properly.

Optional

Location

Best
Location

Return Air

Plenum

Supply Air
Plenum

A-Coil

The UV-Aire can be installed in ducts nine
inches and larger. Each unit comes with a
duct board mounting kit and a patent-
pending angle bracket. A dual lamp model
is available for commercial applications
and/or increased potency. There is also a
model designed specifically for heat pumps
and a model for outdoor installations.

Good: Standard Installation

Better: Patented Angled Installation -
Single Lamp

Best: Two Angled Lamps or
Two Lamps Perpendicular

Note: When multiple lamps are
used, spacing between lamps
should be at least four inches.
Angle option allows longer
lamps to fit in smaller ducts.

12"

18"

Good

Better

Best

18"

16"

Duct

20"

Duct

16"

Duct

16"

Duct