Grizzly G0572 Manuale Utente

-16-

G0572 Hanging Air Filter with Remote

Figure 8. Rubber feet correctly installed

(Underside View).

Note— For permanent table-top mounting, refer
to the Flush Mount procedure on

Page 17, and

install the air filter unit to the tabletop with the
flush mount flange brackets.

Hanging Mount

3. Repeat Step 2 for remaining feet.

Components and Hardware Needed

Qty

Eye bolts ........................................................... 4
Chain, cable, or steel strapping lines ............... 4

Tools Needed
Wrench 12mm ...................................................1

To make the unit operate at the optimum height
of 7' from the floor, you can install the air filter
unit in your shop by hanging it by chain, cable, or
steel strapping.

Flange Bracket Mounting

Holes

Rubber Feet

ONLY hang the air filter to load bearing ceil-

ing studs or joists that can hold at least 100

lbs. DO NOT mount the unit to sheet rock,

pressboard, paneling, or honeycomb ceil-

ing panels with expansion-type fasteners

like the ones shown in Figure 9. The fasten-

ers can tear out and the air filter can fall.

Ignoring this warning can result in severe

injury or death.

To install the air filter for hanging mount

operations:

1. Install four chain, cable, or steel strapping

lines to your ceiling from capable ceiling joists
or supports. When the lines hang down freely
they should be 15

⁄

" from left-to-right and

⁄

" from front-to-rear. Optimally, the unit

should hang 7' off the floor when finished.

Figure 9. Typical unacceptable fasteners.

Get lifting assistance

before installation. At

64 pounds (shipping

weight), the Model G0572

air filter is a heavy load.