Chamberlain 953EV Dépliant

To prevent possible SERIOUS INJURY or 
DEATH from a moving gate or garage door:
•   ALWAYS keep remote controls out of 

reach of children. NEVER permit children 
to operate or play with remote controls.

•   Activate gate or door ONLY when it can be 

seen clearly, is properly adjusted and there 
are no obstructions to door travel.

•   ALWAYS keep gate or garage door in sight 

until completely closed. NEVER permit 
anyone to cross path of moving gate or 
door.

For use with Chamberlain 315 MHz or 390 MHz garage door openers manufactured after 
January 1, 1993. The garage door opener activates when the programmed button on the 
remote control is pressed. The remote control can activate up to three garage door openers.

® 

LED

LED

Locate the Program button on the 
remote control.

Locate the Learn 
button on the garage 
door opener.
NOTE: Your garage door 
opener may look different.

Learn 
LED

Learn 
LED

Learn 
LED

Green
or
Red/Orange

Purple

Yellow

Program Button

Program Button

Press and release the remote 
control button you want to use...

To exit programming mode, press 
any remote control button except 
the button that was just programmed.

Install the visor clip.

The garage door opener 
will activate.

To test, press the programmed button on 
the remote control...

Press and 
release the 
Learn button 
on the garage 
door opener.

Within 30 seconds...

                         To enter 
                          programming 
                          mode, use the 
                          visor clip to 
                     press the Program 
                  button until the LED 
                  on the front of the 
           remote control turns on.

The Learn LED will light.

Check to see if the garage door opener 
light bulb blinks. If not, wait for the 
remote control LED to light solid then 
slowly press and release the remote 
control button again. Repeat until the 
light bulb blinks. 
DO NOT press the button after the 
light bulb blinks.