Lennox Hearth ADK45CPB Dépliant
GENERAL INFORMATION
ARCH DOOR KITS WITH BRASS OR
BRUSHED STAINLESS STEEL TRIM
These arch door kits may be used with gas fireplace models listed in
Tables 1 & 2.
INSTALLATION INSTRUCTIONS FOR ARCH DOOR KITS WITH BRASS OR BRUSHED STAINLESS STEEL TRIM
FOR USE WITH MERIT™, MERIT PLUS™, OR ELITE® SERIES GAS FIREPLACES
INSTALLATION INSTRUCTIONS
Part A: Elite Series Fireplaces
Step 1. Slightly lift and pull the existing top radiant panel/hood assembly
away from the fireplace, or pull hood and slightly lift and pull the
existing louver assembly away from the fireplace.
Step 2. Lift and pull the existing top and bottom bustle away from the
fireplace.
Step 3. Open the bottom compartment door (either a radiant panel or
louver assembly) by pushing in simultaneously the left and right
top corners of the door (the door is hinged at the bottom).
Step 4. Remove the bottom compartment door by sliding the hinge pin,
located at the door’s left side, to the right until it disengages from
the left corner post hole. Pull the door diagonally to the left, away
from the fireplace.
Step 5. Remove the modesty panel as follows: lift the modesty panel by the
tab on the panel’s right end, pull the right end of the panel away from
cabinet and then pull the panel diagonally out of the corner post slots
on the left side of the unit. Remove the modesty panel carefully, so
that none of the wires become loose or disconnected.
P/N 750,021M
REV. E 03/2008
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 1
CAT. NO.
MODEL
WHERE USED
81L34
ADK35CPB
EDV3530, ED3530
81L35
ADK40CPB
EDV4035, ED4035-2, LMDV-4035,
SSDV-4035, MPD4035, EDVST, EDST-2,
EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,
EDCL-2, EBST-2, EBVPF, EBPF-2, EBVCR,
EBCR-2, EBVCL, EBCL-2
81L36
ADK45CPB
EDV4540, ED4540-2, MPD4540
81L37
ADK24CPB
EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,
EDCL-2, EBVPF, EBPF-2, EBVCR, EBCR-2,
EBVCL, EBCL-2
98L05
ADK33CPB
MDR3328, MDT3328, MPDT3328,
MPDR3328, LMDVR-3328
26M43
ADK35CMPB
MPD3530, MPD35ST, MPD35PF, MPB35ST,
LMDV-3530, SSDV-3530
H7026
ADK22CMPB
MPD35PF
Table 1 - Arch Door Kit with Brass Trim
CAT. NO.
MODEL
WHERE USED
98L68
ADK35CBS
EDV3530, ED3530
98L69
ADK40CBS
EDV4035, ED4035-2, LMDV-4035,
SSDV-4035, MPD4035, EDVST, EDST-2,
EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,
EDCL-2, EBST-2, EBVPF, EBPF-2, EBVCR,
EBCR-2, EBVCL, EBCL-2
98L70
ADK45CBS
EDV4540, ED4540-2, MPD4540
98L71
ADK24CBS
EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL,
EDCL-2, EBVPF, EBPF-2, EBVCR, EBCR-2,
EBVCL, EBCL-2
98L62
ADK33CBS
MDR3328, MDT3328, MPDT3328,
MPDR3328, LMDVT-3328, LMDVR-3328
26M44
ADK35CMBS MPD3530, MPD35ST, MPD35PF, MPB35ST,
LMDV-3530, SSDV-3530
H7027
ADK22CMBS MPD35PF
Table 2 - Arch Door Kit with Brushed Stainless Steel Trim
KIT CONTENTS:
TOOLS REQUIRED:
1 ea. Arched Door
1 ea. Instruction Sheet
None
Glass
Frame
Arched Door
Corner Tabs- At
The Four Corners
CAUTION
INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!
LENNOX HEARTH PRODUCTS
KITS AND ACCESSORIES
Step 6. Open the glass door latche(s) located underneath the firebox.
Step 7. Remove the door from the fireplace by swinging the bottom of
the door outward and lifting it up and away.
Step 8. Center the arch door over the glass frame as shown in Figure 1.
Press the arch door onto the glass frame and bend the four corner
tabs into the frame’s U-channel as shown in Figure 2.