Roberts Gorden CGTH-50 Manuale Utente

15

1. This appliance does not have a pilot. It is 

equipped with an ignition device which automat-
ically lights the burner. DO NOT try to light the 
burner by hand.

2. BEFORE OPRERATING smell all around the 

appliance area for gas. Be sure to smell next to 
the floor because some gas is heavier than air 
and will settle on the floor.

3. Use only your hand to push in or turn the gas 

control knob. Never use tools. If the knob will not 
push in or turn by hand, don’t try to repair it, call 
a qualified service technician. Force or 
attempted repair may result in a fire or explo-
sion.

4. DO NOT use this appliance if any part has been 

under water. Immediately call a qualified service 
technician to inspect the appliance and replace 
any part of the control system and any gas con-
trol which has been under water.

.

STOP! Read the safety information above.

1. Set the thermostat to the lowest setting.

2. Turn off all electric power to the heater.

3. Do not try to light the burner by hand.

4. Turn off the manual gas valve in the heater 

supply line.

5. Wait five (5) minutes to clear out any gas. If you 

then smell gas, STOP! If you do not smell gas, 
go to the next step.

6. Open the manual gas valve in the heater supply 

line.

7. Turn on electric power to the heater.

8. Set the thermostat to the desired setting.

9. If the heater will not operate, 

See Section 5.5 

and call your service technician or gas supplier.

1. Set the thermostat to the lowest setting.