Desa VM36E Manuale Utente

108796

Minimum clearances to combustibles are:
• Back and Sides of Outer Surround ............................ 0" min.
• Drywall to Sides of  Front Face (Nailing Flanges) ... 0" min.
• “B” Vent Surfaces ..................................................... 1" min.
• Ceiling to Opening .................................................. 42" min.
• Floor .......................................................................... 0" min.
• Perpendicular Wall ............................... See Figure 6, page 7

0"

0" Clearance

Nailing
Flange

Front Face

Left Side
Surround

Back

Drywall

2 x 4 Stud

*

*

*

*

42" (1067mm)
Min. Clearance
from Opening to 
Ceiling

0" Clearance

Ceiling

1" (25mm) Min.
Clearance to 
"B" Vent’s Outer Pipe

Maintain 2" (51mm) Min.
Clearance to the Transition
Pipe as Measured at the 
Outer Vent Collar

Required Air 
Spaces are
Indicated with 
an "

*

".  Do Not 

Pack with 
Insulation or Any
Other Material

DO NOT BLOCK

OR OBSTRUCT

OPENINGS

0" Clearance 
to Wood or 
Noncombustible
Flooring

To determine the safest and most efficient location for your appli-
ance, you must take into consideration the following guidelines:

1.

The location must allow for proper clearances (see Clearances,
next column).

2.

Consider a location where heat output would not be affected
by drafts, air conditioning ducts, windows, or doors.

3.

A location that avoids the cutting of joists or roof rafters will
make installation easier. Figure 2 shows a plan view of a few
common locations.

 are recommended where living space is

limited or at a premium, and since the space required to enclose the
appliance would be located beyond an outside wall, this would also
reduce the cutting of joists, roof rafters, and such. Check local codes
for any restrictions.

 can extend any distance into the room. A

projection may be ideal for a new addition on an existing, finished wall.

 make use of space that may not normally be

used and provides a wider and more efficient range for radiant heat
transference.

 provide a discreet option for room

separation and can also be ideal as an addition to an existing wall.

INTERNAL WALL
INSTALLATION

CORNER
INSTALLATION

FULL
PROJECTION
INSTALLATION

FLUSH
INSTALLATION