Desa E36L Manuale Utente
www.desatech.com
111076-01F
10
ACCESSORy INSTALLATION
Continued
5. Insert brick panel, beveled edge first,
through firebox opening. Tilt and angle top
edge into brick retainer until beveled edge
contacts imager and panel is flat against
firebox (see Figure 17).
edge into brick retainer until beveled edge
contacts imager and panel is flat against
firebox (see Figure 17).
6. Align hearth pan bracket over holes near
lower edge of brick panel and secure with
2 pan screws provided.
2 pan screws provided.
7. Replace refractory bracket using 2 screws
removed in step 4, page 9.
8. Repeat steps 5 through 7 for opposite
panel assembly.
9. Replace each screen assembly by po-
sitioning screen rod into locating holes
under top edge of firebox and securing
with 2 Phillips screws removed in step 2,
page 9.
under top edge of firebox and securing
with 2 Phillips screws removed in step 2,
page 9.
.
Note: Rods may have to be angled into
locating holes at the top of each screen
pocket. Once inserted, pull free end of rod
forward until it lines up over farthest mount-
ing hole respectively so rods overlap.
locating holes at the top of each screen
pocket. Once inserted, pull free end of rod
forward until it lines up over farthest mount-
ing hole respectively so rods overlap.
10. Replace log bed over hearth opening
and center between grate and viewing
screen.
screen.
11. Replace glass doors if removed. See
Optional Glass Doors, page 8.
OPTIONAL HEATER ACCESSORY
WARNING: Disconnect
power before attempting any
maintenance or cleaning to re-
duce the risk of fire, electrical
shock or personal injury.
Blower/heater kit model BHKE is available
for models E36/32L and E36/32LB. Either
of 2 types of blower/heater assemblies can
be installed.
1. Open upper control door (see Figure 10,
for models E36/32L and E36/32LB. Either
of 2 types of blower/heater assemblies can
be installed.
1. Open upper control door (see Figure 10,
on page 7) and remove 2 Phillips screws
below heater grill on control panel (see
Figure 18, page 11).
below heater grill on control panel (see
Figure 18, page 11).
2. Remove 2 Phillips screws holding control
cover to control panel inside firebox (see
Figure 14, page 9).
Figure 14, page 9).
3. Slide control cover to the right and swing
out locking tabs from notched openings
on top (see Figure 18, page 11).
on top (see Figure 18, page 11).
4. Let control cover hang down off har-
nesses. Be careful not to damage any
wiring. If necessary, unscrew harness
strap at blower mount to gain slack.
wiring. If necessary, unscrew harness
strap at blower mount to gain slack.
5. Remove 2 hex screws at rear of blower
mount (see Figure 18, page 11).
Figure 16 - Removing Refractory Bracket
and Hearth Pan Bracket
Face Panel
(Models E36L
and E36LH
Only)
(Models E36L
and E36LH
Only)
Hearth Pan Bracket
(Models E36L and
E36LH Only)
(Models E36L and
E36LH Only)
Refractory.
Bracket
Bracket
Figure 17 - Installing Brick Panels and
Brackets
Refractory.
Retainer
Bracket
Retainer
Bracket
Hearth Pan
Bracket
Bracket
Refractory.
Bracket
Bracket