FireplaceXtrordinair 44 DV XXL EF Manuale Utente

4050114

8

 

Run the free wire from the rheostat junction box to the fireplace.  Follow the directions below to connect the
heat duct circuit to the fireplace.

Insert the sheathed cable from the rheostat through a 

cable clamp and push the cable clamp into the knock-out 

hole to secure it in place.  Once the wires are attached, 

tighten the clamp to secure the  cable.

Replace 

the cover 

removed 

in step "a".

Attach the common (white), ground (exposed or green) wires, and hot 

(black) wires from the cable leading to the rheostat to the molex 

connector.  Then attach the molex connector to the fireplace.

Standard 

Screwdriver

Power 

Source 

for 

Fireplace

Remove the cover from the 

fireplace junction box.

Note: you may need to loosen this cable 

clamp to ease removal of the cover plate.

1/4" Nutdriver

Electrical Connector 

(included with the 

heat duct kit)

To optional second 

power heat vent (use 

the center knock-out).

Pry out and discard 

this knock-out.

Standard 

Screwdriver

Once a year the grate should be removed and the blower area cleaned.  Use a vacuum to clean around the
squirrel-cage blower, being careful not to damage any of the blades.

A

A

A

A

A

A

A

A

A

A

A

A

AA

AA

AA

AA

AA

AA

AA

AA

AA

AA

Grill

Phillips 

Screwdriver

Use a vacuum cleaner to remove 

any debris from the power vent 

blower.

Follow the directions included with the remote for installation with the exception of the receiver heat shield.
For the 44 DV EF, use the modulating remote receiver heat shield included inside the fireplace (to the left of
the gas control valve) instead of the heat shield included with the kit.