Multiquip JB5090 Manuale Utente

1. Place the pump control valve lever

  (Figure 8) in the

neutral position.

2. Send the end of the spiral rebar through the gap in the puller

hook. Secure the puller hook around the straight rebar and
align the puller rollers on the spiral rebar (Figure 15).

3. Place the pump control valve lever in the 

position.

4. Place and hold the  toggle switch on the remote control

unit (ON position). The rebar bending process should
begin.

5. Activating the rebar bender will then cause the puller

hook and cylinder to retract and curl the end of the spiral
rebar up to 135° around the straight rebar.

6. When the desired angle has been achieved, release the

toggle switch on the remote control unit. This will stop the
retraction of the puller hook and cylinder.

7. To extend the puller hook and cylinder, place the pump

control valve lever in the 

reverse/retract position.

8. To remove the rebar bender, place the pump control

 valve

lever in the 

neutral position and lift the bender over the

end of the rebar.

1. Place the pump control valve lever

  (Figure 8) in the

neutral position.

2. Send the end of the spiral rebar through the gap between

the puller hook and main roller. Rotate the main roller so
that the main roller groove is in the 1 o’clock position.
Secure the straight rebar in the main roller groove. Align
the puller rollers on the spiral rebar (Figure 16).

3. Operate rebar bender as outlined in Method 3, steps 3 thru 8.