Haier HTWR10XCK Manuale Utente
INSTALLATION INSTRUCTIONS
Remove old air conditioner and inspect sleeve for the following:
Insallation--Make sure that sleeve is securely installed and in
sound structural condition.
Dimensions--Measure the size to make sure the air conditioner
ZLOO¿W
Slope--There should be a rearward slope for condensate to
drain from the rear of the sleeve.
Chece against Fig.A.
Insallation--Make sure that sleeve is securely installed and in
sound structural condition.
Dimensions--Measure the size to make sure the air conditioner
ZLOO¿W
Slope--There should be a rearward slope for condensate to
drain from the rear of the sleeve.
Chece against Fig.A.
There are sharp edges that can cause serious cuts.
When lifting the air conditioner,it is HEAVY. Use 2 peoples to lift.
When lifting the air conditioner,it is HEAVY. Use 2 peoples to lift.
CAUTION
For New Construction install Haier Wall Sleeve.
Manufacturer--So the method of installation can be determined.
If the installation and slope are suspect,then removal and
correct installation of a Haier Wall Sleeve,is recommended.
If the installation and slope are suspect,then removal and
correct installation of a Haier Wall Sleeve,is recommended.
Check the conetents of the accessories supplied with your air
conditioner as shown below:
conditioner as shown below:
2
1
6
9
10
5
8
7
4
3
How to install
1.Identify the existing wall sleeve before installing the unit
from the listed below.
from the listed below.
Note:All wall sleeves used to mount the new Air Conditioner
must be in sound structural condition and have a rear grille
WKDWVHFXUHO\DWWDFKHVWRVOHHYHRUUHDUÀDQJHWKDWVHUYHVDVD
stop for the Air conditioner.
must be in sound structural condition and have a rear grille
WKDWVHFXUHO\DWWDFKHVWRVOHHYHRUUHDUÀDQJHWKDWVHUYHVDVD
stop for the Air conditioner.
2.Clean the interior of the sleeve (do not disturb seals).
3.Repaint the sleeve if needed.
4.On 25
3.Repaint the sleeve if needed.
4.On 25
13/32
”-26”sleeves:Replace the existing louvered grille
with the new one supplied in the package,shown in the Fig.B
4
REAR
Wall Sleeve
UNIT
LEVEL
FRONT
to
Fig.A
Brand
Wall Sleeve Dimensions(inches)
25-1/2
25-13/32
26
25-7/8
25-7/8
27
25-7/8
25-3/4
Height
15-1/4
15-3/4
15-9/16
Width
White-westinghouse
Haier Amana
Frigidaire
Carrier(52F series)
Carrier(52F series)
General Electric /Hotpoint
15-5/8
Whirlpool
16-1/2
Fedders/Emerson
16-3/4
16-3/4
Sears/Kenmore
15-17/32
16-7/8
Carrier(51S series)
Depth
16,17-1/2
or 22
or 22
16-7/8
17-1/2
17-1/8
16-3/4
or 19-3/4
or 19-3/4
16-23/32
18-5/8
Emerson/Fedders
Friedrich
26-3/4
15-3/4
15
27
16-3/4
16-3/4
LG
25-7/8
15-17/32
16-23/32
Haier Amana
Number
Part name
QTY.
1
2
3
4
5
6
7
8
2
2
2
2
Wide Top/Bottom Trim Frame
Wide Side Trim Frame
Narrow Side Trim Frame
Narrow Top/Bottom Trim Frame
Universal Fit Rear Grille
1
Tapered Spacer Block
2
Board
1
Foam Seal
1
Screw
4
4
Washer
9
10