Quasar HQ-2244UH Manuale Utente
5
About
the
Controls
Controls
on
the
Air
Air
Conditioner
6
2
1
8
3
4
7
OPERATION
TEMP
TIMER
AIR
SWING
MODE
ECONOMY
FAN SPEED
1
6
2
4
5
3
7
About the Controls on the Air Conditioner
Controls
OPERATION BUTTON
• To turn the air conditioner ON, push the button.
• To turn the air conditioner ON, push the button.
To turn the air conditioner OFF, push the button
again.
again.
• This button takes priority over any other buttons.
• When you first turn it on, the air conditioner is on
• When you first turn it on, the air conditioner is on
the High cool mode and the temp. at 72°F(22°C)
OPERATION MODE SELECTION BUTTON
Every time you push this button. It will toggle
between COOL, ECONOMY, FAN and DRY.
Every time you push this button. It will toggle
between COOL, ECONOMY, FAN and DRY.
ROOM TEMPERATURE SETTING BUTTON
This button can automatically control the
temperature of the room. The temperature can
be set within a range of 60°F to 86°F by 1°F.
(16°C to 30°C by 1°C)
Select the lower number for lower temperature
of the room.
This button can automatically control the
temperature of the room. The temperature can
be set within a range of 60°F to 86°F by 1°F.
(16°C to 30°C by 1°C)
Select the lower number for lower temperature
of the room.
FAN SPEED SELECTION BUTTONS
Every time you push this button, it is set as
follows.
{High(F3)
Every time you push this button, it is set as
follows.
{High(F3)
→ Low(F1) → Med(F2) → High(F3)...}.
ECONOMY
• If you push the button, the fan stops when the
• If you push the button, the fan stops when the
compressor stops cooling. Approximately every
3 minutes the fan will turn on and check the
room air to determine if cooling is needed.
3 minutes the fan will turn on and check the
room air to determine if cooling is needed.
ON/OFF TIMER BUTTON
You can set the time when the unit will turn on or turn
off automatically by pressing the timer button. If the
unit is operating, this button controls the time it will be
turned off. If the unit is in off state, this button controls
the time it will start. Every time you push this button,
the remaining time will be set as follows.
You can set the time when the unit will turn on or turn
off automatically by pressing the timer button. If the
unit is operating, this button controls the time it will be
turned off. If the unit is in off state, this button controls
the time it will start. Every time you push this button,
the remaining time will be set as follows.
- STOPPING OPERATION
• Every time you push this button, when the air
• Every time you push this button, when the air
conditioner is operating, timer is set as follows.
(1Hour
(1Hour
→ 2Hours → 3Hours → 4Hours → 5Hours →
6Hours
→ 7Hours → 8Hours → 9Hours → 10Hours →
11Hours
→ 12Hours → 0Hour → 1Hour → 2Hours → ...)
• The Setting Temperature will be raised by 2°F(1°C)
30min. later and by 2°F(1°C) after another 30 min.
- STARTING OPERATION
• Every time you push this button, when the air conditioner
• Every time you push this button, when the air conditioner
is not operating, timer is set as follows. (1Hour
→ 2Hours
→ 3Hours → 4Hours → 5Hours → 6Hours → 7Hours →
8Hours
8Hours
→ 9Hours → 10Hours → 11Hours → 12Hours →
0Hour
→ 1Hour → 2Hours → ...)
AIR SWING BUTTON
This button can automatically control the air
flow direction.
REMOTE CONTROL SIGNAL RECEIVER
This button can automatically control the air
flow direction.
REMOTE CONTROL SIGNAL RECEIVER
DRY
• When this unit is in dry mode, the fan rotates in low
• When this unit is in dry mode, the fan rotates in low
speed. The fan stops when the compressor stops
cooling.
Approximately every 3 minutes the fan will turn on and
the unit checks the room air temperature to set itself.
cooling.
Approximately every 3 minutes the fan will turn on and
the unit checks the room air temperature to set itself.
7
7
6
6
8
8
9
9
Precaution: The Remote Controller will not function properly if strong light strikes the sensor
window of the air conditioner or if there are obstacles between the Remote Control
unit and the air conditioner.
unit and the air conditioner.