Dometic VN 830 Manuale Utente
english
volvo l-5 a/c - air distribution system
The instructions that follow represent years of development of parts and procedures
that make the system perform well and appear “factory-installed.”
that make the system perform well and appear “factory-installed.”
intRoduction
installing the contRol
Mount the control in a place that provides the driver
convenient access. An ideal location would be near
the current HVAC controls.
convenient access. An ideal location would be near
the current HVAC controls.
Required tools
• Drill motor
• Hole saws: 1-5/8", 1-7/8", 2-1/2", 3.5" (for 10K unit)
• Hole saws: 1-5/8", 1-7/8", 2-1/2", 3.5" (for 10K unit)
and 4"
• Drill bits: 1/8", 5/32", 9/32"
• Nut drivers: 1/4", 3/8", 15/16"
• Phillips head screwdriver
• Open-end wrenches: (2) 7/16", (1 each) 5/16", 13/16"
• Nut drivers: 1/4", 3/8", 15/16"
• Phillips head screwdriver
• Open-end wrenches: (2) 7/16", (1 each) 5/16", 13/16"
& 3/4"
• Torque wrench may be also be required
Figure 1. Typical Control Installation
installing the Qt digital display
Refer to the mounting instructions and template
provided with your kit.
provided with your kit.
• Route the CXP cable through the wall and into the
luggage compartment. Remove the factory HVAC
control panel to do this.
control panel to do this.
• Route the CXP cable to the rear of the bunk for later
connection.