Lopi 028-S-75-2 Manuale Utente

© Travis Industries

100-01177

4060802

The rear blower improves heat transfer by pushing heated air through the convection channel. Operating
instructions are described in the section "Blower Operation".

Route the wires on the 

outside of the stove, behind 

the convection jacket.

Tuck the thermodisk into place.  It 

wedges between the rear heat sheild 

and the cast iron firebox.

Bend the legs of the 

thermodisk bracket to 

make it 1-1/2” deep.

1-1/2”

3/8" Wrench

Plug the blower in.  Do not route the power cord under or over the stove or in a 

location where it may become damaged.

Route the wires from the blower through the hole 

in the back of the blower housing. Attach these 

wires to the thermodisk wires.

Position the blower near the rear of the stove.  Tuck all excess wire into the 

blower box, making sure it does not contact any moving parts.  Make sure when 

installing the blower, these wires do not become loose.

Attach the blower to the 

stove with the three screws 

included with the blower.