Regency F37-NG Manuale Utente

Pagina di 28
F37 Regency
®
 Rear Flued Room Sealed Freestanding Gas Heater
5
INSTALLATION AND REPAIRS 
SHOULD BE DONE BY AN AU-
THORIZED SERVICE PERSON. 
THIS APPLIANCE SHOULD BE 
INSTALLED, REPAIRED, IN-
SPECTED BEFORE USE AND 
AT LEAST ANNUALLY BY AN 
AUTHORIZED SERVICE PERSON.  
MORE FREQUENT CLEANING 
MAY BE REQUIRED DUE TO EX-
CESSIVE LINT FROM CARPET-
ING, ETC.  IT IS IMPERATIVE THAT 
THE CONTROL COMPARTMENT, 
BURNERS AND CIRCULATING 
AIR PASSAGEWAYS OF THE AP-
PLIANCE BE KEPT CLEAN.
IMPORTANT  
SAVE THESE 
INSTRUCTIONS
The REGENCY Rear Flued Room Sealed 
Freestanding Gas Stove must be installed in 
accordance AG601 and NZS 5261 and with these 
instructions. Carefully read all the instructions in 
this manual fi rst. Consult the building authority 
having jurisdiction to determine the need for a 
permit prior to starting the installation.
Note: Failure to follow the instructions 
could cause a malfunction of the 
heater which could result in death, 
serious bodily injury, and/or prop-
erty damage.  Failure to follow these 
instructions may also void your fi re 
insurance and/or warranty.
SPECIFICATIONS
Fuels: 
F37-NG is approved for use with 
NG.
 
 
F37-LPG is approved for use with 
liquefi ed petroleum gases (LPG).
Electrical: 240 V   A.C. system.
Circulation Fan:  Two Speed
Log Sets:  Ceramic fi bre, 7 per set.
Flue System: 
 
 
Axial (6-5/8" outer / 4" inner liner) rigid 
fl ue and Riser Vent Terminal.
 
BEFORE YOU START
Safe installation and operation of this appliance 
requires common sense, however, please  be 
aware of the following:
INSTALLATION
manufactured home the unit must be bolted 
down to the fl oor.
4)  We recommend that you plan your instal-
lation on paper using exact measurements 
for clearances and fl oor protection before 
actually installing this appliance.  Have an 
authorized building inspector review your 
plans before installation.
GENERAL SAFETY 
INFORMATION
1)  The appliance shall be installed in accord-
ance with the manufacturer's installation 
instructions, local gas fi tting regulations, 
municipal building codes, water supply 
regulations, electrical wiring regulations, 
with AS5601-2004 (AGA gas installation 
code) NZS 5261 (New Zealand)
2)  Installation and repair should be done 
ONLY by an authorised person.  
3)  DO NOT CONNECT TO MASONARY 
FLUE.
4)  This appliance must be connected to 
the specifi ed  fl ue and termination cap 
to the outside of the building envelope. 
Never fl ue to another room or inside a 
building. Make sure that the fl ue is fi tted 
as per Flueing instructions.
5)  Inspect the fl ueing system annually for 
blockage and any signs of deterioration.   
6)  Flueing terminals shall not be recessed into 
a wall or siding.
7)  Any safety glass removed for servicing 
must be replaced prior to operating the ap-
pliance.
8)  To prevent injury, do not allow anyone who 
is unfamiliar with the operation to use the 
fi replace.
9)  Wear gloves and safety glasses for protec-
tion while doing required maintenance.
10) Be aware of electrical wiring locations in 
walls and ceilings when cutting holes for 
termination.
11) Under no circumstances should this ap-
pliance be modifi ed. Parts that have to be 
removed for servicing should be replaced 
prior to operating this appliance.
12)  Installation and any repairs to this appliance 
should be done by an authorised service 
person. An authorised service person should 
be called to inspect this appliance annually. 
DUE TO HIGH TEMPERATURES, 
THE APPLIANCE SHOULD BE 
LOCATED OUT OF TRAFFIC AND 
AWAY FROM FURNITURE AND 
DRAPERIES.
WARNING: FAILURE TO INSTALL 
THIS APPLIANCE CORRECTLY 
WILL VOID YOUR WARRANTY AND 
MAY CAUSE A SERIOUS HOUSE 
FIRE.
CHILDREN AND ADULTS SHOULD 
BE ALERTED TO THE HAZARDS 
OF HIGH SURFACE TEMPERA-
TURES, ESPECIALLY THE FIRE-
PLACE GLASS, AND SHOULD 
STAY AWAY TO AVOID BURNS OR 
CLOTHING IGNITION.  
YOUNG CHILDREN SHOULD BE 
CAREFULLY  SUPERVISED WHEN 
THEY ARE IN THE SAME ROOM AS 
THE APPLIANCE.  
CLOTHING OR OTHER FLAM-
MABLE MATERIAL SHOULD NOT 
BE PLACED ON OR NEAR THE 
APPLIANCE. 
1)  Provide adequate clearances for servicing, 
proper operation and around the air openings 
into the combustion chamber. 
2)  The appliance must be installed on a fl at, 
solid, continuous surface (e.g. wood, metal, 
concrete). This may be the fl oor, or it can 
be raised up on a platform to enhance 
its visual impact. The appliance may be 
installed on carpeting, tile, wood fl ooring 
or other combustible material, because the 
appliance's metal pedestal base extends 
the full width and depth of the appliance. 
The REGENCY Rear Flued Room Sealed 
Freestanding Gas Stove can be installed in 
a wide variety of ways and will fi t nearly any 
room layout. It may be installed in a recessed 
position, framed out into the room, or across 
a corner.
3)  The REGENCY Rear Flued Room Sealed 
Freestanding Gas Stove is approved for 
manufactured home installations, see 
"Locating Your Gas Stove" to "Flueing 
Installation Precaution" sections for the re-
quired fl ue arrangements. If installed into a