Regency E33-LP Manuale Utente

E33 FPI Direct Vent Gas Insert

11) Push the FPI logo plate into the two holes 

in the bottom left corner of the faceplate.

The standard fl ush door comes with a black 
frame. To install the frame, simply hook the top 
door fl ange onto the top of the unit and swing 
the door towards the unit, (Diagram 1 and 2). 
Be careful that the glass gasket does not roll up; 
there must be a gap between the gasket and 
the door lip to ensure that the door sits securely 
on the unit. Refer to Diagram 3.

10) Attach the faceplate panels to the insert 

body using the 4 remaining black screws. 
Refer to Diagram 5.

Secure door by fastening with two screws located 
at bottom of glass frame (refer to Diagram 1).

To remove the fl ush door, reverse the above 
steps.

2)  Install the Spring Hinges on the left and right 

side of the bottom of the Firebox using 2 
screws per hinge.

3)  Place the Bottom Louver near the hinge. Flip 

hinge over the Bottom Louver and secure 
using 3 screws.

1)  The top louver is held in place by friction fi t. 

Refer to Diagram 1

4)  Install the Top Frame by hooking it onto the  

two screws at the top of the full screen door. 
It is held in place by magnets.

1)  Hold the full screen faceplate up against 

the unit in order to make the following wire 
connections.

 

Pull the ON/OFF connector wires thru the 
box and connect them to the switch.

 

Connect the fan switch wires with the wire 
connectors from the fan speed control. Place 
clips over wires and tuck into side trim. 

2)  Lift the unit up slightly and push down on 

the corners of the Bottom Trim Bracket and 
slide under unit.

3)  Completely secure faceplate to the unit by 

securing 4 screws to the Left and Right Side 
Trim.