Quadra-Fire CB1200M-MBK Manuale Utente

R 

December 16, 2011

7014-179D

Page 21

1.  Place the front log in first as shown in

Figure 21.1. Place

log between firepot and face of appliance with charred

area surrounding firepot.

2.  Set the left and right logs onto the front log, placing

the holes in the base of the left and right logs over the

locating pins in front log. See

Figure 21.2. Ensure that

the charred ends are facing the firepot.

Logs are FRAGILE. Use extreme care when handling or

cleaning logs.

NOTE:

Due  to  the  abrasive  nature  of  a  pellet  appliance  fire,  the

logs are not covered under warranty. Any placement varia-

tion other than shown here can cause excessive heat and

shall void the appliance warranty.

supported by the hinges. It will damage the hinges.  Prop the

1.  Remove grille from packaging.
2.  Lift top up and place shipping box in vertically.
3.  Place 1 flap of the box lid into opening for stability.
4.  Align the 3 holes in the stove with the holes in the grille.
5. Use a Phillips screwdriver to secure in place.
6. Remove shipping box and lower top.

Install Logo

1.  Remove logo from packaging.
2.  The logo has 2 studs on the back.
3.   Install the logo on the lower left side of the center

panel by pressing the 2 studs into the pre-drilled

holes.

Do not open top all the way back so the weight of the

top is supported by the hinges.

hinges.  It will be necessary to prop the top up with

a supporting brace. You can use the shipping box as

shown in Figure 1.