Regency FG37-NG Manuale Utente

FG37 Regency Rear Flued Room Sealed Freestanding Gas Heater

INSTALLATION AND REPAIRS

SHOULD BE DONE BY AN AUTHOR-

IZED SERVICE PERSON. THIS AP-

PLIANCE SHOULD BE INSTALLED,

REPAIRED, INSPECTED BEFORE

USE AND AT LEAST ANNUALLY

BY AN AUTHORIZED SERVICE PER-

SON. MORE FREQUENT CLEAN-

ING MAY BE REQUIRED DUE TO

EXCESSIVE LINT FROM CARPET-

ING, ETC. IT IS IMPERATIVE THAT

THE CONTROL COMPARTMENT,

BURNERS AND CIRCULATING AIR

PASSAGEWAYS OF THE APPLI-

ANCE BE KEPT CLEAN.

IMPORTANT:

SAVE THESE

INSTRUCTIONS

The REGENCY Rear Flued Room Sealed Free-

standing Gas Stove must be installed in accord-

ance AG601 and NZS 5261 and with these

instructions. Carefully read all the instructions

in this manual first. Consult the building authority

having jurisdiction to determine the need for a

permit prior to starting the installation.

Note: Failure to follow the instructions

could cause a malfunction of the

heater which could result in death,

serious bodily injury, and/or prop-

erty damage. Failure to follow these

instructions may also void your

fire insurance and/or warranty.

SPECIFICATIONS

Fuels:

FG37-NG is approved for use with

NG.

FG37-LPG is approved for use with

liquefied petroleum gases (LPG).

Electrical: 240 V A.C. system.

Circulation Fan: Two Speed

Log Sets: Ceramic fibre, 7 per set.

Flue System:

Axial (6-5/8" (168mm) outer / 4"

(102mm) inner liner) rigid flue and

Riser Vent Terminal.

BEFORE YOU START

Safe installation and operation of this appliance

requires common sense, however, please be

aware of the following:

INSTALLATION

4) We recommend that you plan your installa-

tion on paper using exact measurements

for clearances and floor protection before

actually installing this appliance. Have an

authorized building inspector review your

plans before installation.

GENERAL SAFETY

INFORMATION

1) The appliance shall be installed in accord-

ance with the manufacturer's installation

instructions, local gas fitting regulations,

municipal building codes, water supply reg-

ulations, electrical wiring regulations, with

AS5601-2004 (AGA gas installation code)

NZS 5261 (New Zealand)

2) Installation and repair should be done

ONLY by an authorised person.

3) DO NOT CONNECT TO MASONARY FLUE.

4) This appliance must be connected to

the specified flue and termination cap

to the outside of the building enve-

lope. Never flue to another room or

inside a building. Make sure that the

flue is fitted as per Flueing instruc-

tions.

5) Inspect the flueing system annually for

blockage and any signs of deterioration.

6) Flueing terminals shall not be recessed into

a wall or siding.

7) Any safety glass removed for servicing

must be replaced prior to operating the

appliance.

8) To prevent injury, do not allow anyone who

is unfamiliar with the operation to use the

fireplace.

9) Wear gloves and safety glasses for pro-

tection while doing required maintenance.

10) Be aware of electrical wiring locations in

walls and ceilings when cutting holes for

termination.

11) Under no circumstances should this appli-

ance be modified. Parts that have to be

removed for servicing should be replaced

prior to operating this appliance.

12) Installation and any repairs to this appliance

should be done by an authorised service

person. An authorised service person

should be called to inspect this appliance

annually. Make it a practice to have all of

your gas appliances checked annually.

13) Do not slam shut or strike the glass door.

DUE TO HIGH TEMPERATURES,

THE APPLIANCE SHOULD BE LO-

CATED OUT OF TRAFFIC AND

AWAY FROM FURNITURE AND

DRAPERIES.

WARNING: FAILURE TO INSTALL

THIS APPLIANCE CORRECTLY

WILL VOID YOUR WARRANTY AND

MAY CAUSE A SERIOUS HOUSE

FIRE.

CHILDREN AND ADULTS SHOULD

BE ALERTED TO THE HAZARDS OF

HIGH SURFACE TEMPERATURES,

ESPECIALLY THE FIREPLACE

GLASS, AND SHOULD STAY AWAY

TO AVOID BURNS OR CLOTHING

IGNITION.

YOUNG CHILDREN SHOULD BE

CAREFULLY SUPERVISED WHEN

THEY ARE IN THE SAME ROOM AS

THE APPLIANCE.

CLOTHING OR OTHER FLAMMA-

BLE MATERIAL SHOULD NOT BE

PLACED ON OR NEAR THE APPLI-

ANCE.

1) Provide adequate clearances for servic-

ing, proper operation and around the air

openings into the combustion chamber.

2) The appliance must be installed on a flat,

solid, continuous surface (e.g. wood, met-

al, concrete). This may be the floor, or it can

be raised up on a platform to enhance its

visual impact. The appliance may be in-

stalled on carpeting, tile, wood flooring or

other combustible material, because the

appliance's metal pedestal base extends

the full width and depth of the appliance.

The REGENCY Rear Flued Room Sealed

Freestanding Gas Stove can be installed in

a wide variety of ways and will fit nearly

any room layout. It may be installed in a

recessed position, framed out into the room,

or across a corner.

3) The REGENCY Rear Flued Room Sealed

Freestanding Gas Stove is approved for

manufactured home installations, see pag-

es 6 to 9 for the required flue arrangements.

If installed into a manufactured home the

unit must be bolted down to the floor.