Regency E33-NG Manuale Utente

E33 FPI Direct Vent Gas Insert

9)  Attach the trim to the faceplate by using the 

plated screws (refer to Diagram 4).

1)  Lay the faceplate panels fl at, face down on 

something soft so they don't scratch.

2)  Take the top faceplate and align the holes 

in it with the holes in the side panels.  Us-
ing the screws provided, attach from the 
top of the panel (the holes in the top panel 
are slightly larger than the holes in the side 
panel to facilitate easier installation). Refer 
to Diagram 1.

 

Hint: Don't tighten the screws down com-
pletely at this point, continue on with steps 
3 and 4 and do a trial fi t to the unit.  Make 
any necessary adjustments and when it fi ts 
properly then tighten down the screws.

7)  Tuck the wires into the faceplate to keep 

them away from the insert using the clip 
provided. Attach the clip to the rear of the 
faceplate to ensure that the wires do not 
touch the side of the unit. Refer to Diagram 
3.

8)  The power cord should be run behind the 

faceplate panel.

4)  Place the trim on the assembled faceplate 

panels, aligning the wire connections from 
the switches with the notch on the left side 
panel.

5)  Connect the fan switch wires by taking the 

black and red wires with the male ends (in 
the grey harness) and connect them with 
the wire connectors from the fan speed 
control.

6)  Connect the ON/OFF switch wires by taking 

the black and red wires with the female ends 
and connect them to the ON/OFF switch.

“Maintenance Instructions” (page 20) for 
correct fl ame patterns.

18) Check inlet (12” WC min) and outlet (11” 

WC) pressures. Refer “Gas Pipe Pressure 
Testing” (page 9).

19) Check operation of fl ame control.

20) Check for proper fl ame appearance and 

glow on logs. 

3)  Using the connectors provided, join the left 

side trim (with the ON/OFF switch) to the 
top trim. Diagram 2. Connect the right side 
trim to the top trim.