Quadra-Fire MTVERNON-AE-PMH Manuale Utente

R

September 1, 2008

7034-106E

Page  19

1. 

Put a layer of high temperature silicone on the 
3 inch (76mm) exhaust outlet. Figure 19.1.

2. 

Slide the top vent adapter onto the rear exhaust 
outlet and adjust the assembly to a vertical position 
until the top of the flue outlet is centered and is in 
a level position.  Figure 19.1.

3. 

Align slot on left of adapter with hole in the back of 
the unit and secure with screw.  You may drill out the 
hole using #26 drill bit provided but only if needed.
Figure 19.2.

4. 

Install the 5 mounting screws, 3 on the left and 2 
on the right.

5.   Drill 2 holes with #26 drill bit through the rear 

exhaust outlet using the 2 holes already in the short 
horizontal pipe in the top vent adapter as a guide. 
Install the screws.  Figure 19.2.

6. 

Install the vent pipe into the top vent adapter (be 
sure to silicone all joints).  To use an existing 6 
inch (152mm) vent system, install the 3 to 6 in (76-
152mm) offset adapter before installing vent pipe.

7.  To clean top vent adapter, open clean-out cover 

and remove any debris build-up.  Figure 19.2.

3 in. to 6 in. 

Offset Adapter

Silicone Rear 

Exhaust Outlet

3 in. to 3 in. Top 

Vent Adapter

Clean-Out

Cover

Drill Hole, 1 

on each side

Align slot holes on the adapter 
to holes on the  a k of the  nit

Clean-Out Cover

Clean-Out Cover

1. 

Put a layer of high temperature silicone on the 3 inch 
(76mm) exhaust outlet. Figure 18.1.

2. 

Slide the adapter onto the rear exhaust outlet and 
adjust the assembly to the appropriate position.  

3.  Install the vent pipe into the adapter (be sure to 

silicone all joints)