Quadra-Fire QUADRA-FIRE CONTOUR Manuale Utente
1445 N. Highway
Colville, WA 99114
www.aladdinhearth.com
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY NOTES
1. When installing your stove, particular attention should be paid to fire protection. If this unit is not properly installed, a house
fire may result. For your safety, follow the installation instructions, and contact local building or fire officials about restrictions
and installation inspection required in your area.
2. Read power supply section of component information (page 15) before you plug in the stove.
3. Always unplug the stove before cleaning or servicing.
4. During operation, if any part of the stove starts to glow, the stove is in an overfired condition. Reduce the feed rate and increase
the amount of air going into the stove. OVERFIRING VOIDS WARRANTY.
5. Do not install a flue damper in the exhaust venting system of this unit.
6. Do not connect the stove to a chimney flue already serving another appliance.
7. Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or freshen up a fire in
this heater. Keep all such liquids well away from the heater while it is in use.
8. The stove operates with a negative pressure firebox and a positive pressure exhaust. It is imperative that the chimney system
be airtight and installed correctly.
9. Dispose of all ashes in a metal container.
10. Comply with all minimum clearances to combustibles as shown on page 5.
11. The Quadra-Fire Contour is tested and approved for pelleted biomass fuel or shelled field corn only. Burning of any other
type of fuel voids your warranty!
12. Aladdin Hearth Products, manufacturer of the Contour pellet stove, reserves the right to alter its products, their specifications
and/or price without notice.
13. ALADDIN HEARTH PRODUCTS, GRANTS NO WARRANTY, IMPLIED OR STATED, FOR THE INSTALLATION OR
MAINTENANCE OF THIS UNIT AND ASSUMES NO RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S).
CONTOUR PELLET STOVE
INSTALLATION, OPERATION, AND MAINTENANCE INSTRUCTIONS
Please read this entire manual before installation and use of this pellet fuel room heater.
Failure to follow these instructions could result in property damage, bodily injury or even death.
O-T L
Tested and
Listed by
Beaverton
Oregon USA
OMNI-Test Laboratories, Inc.
C
PRIOR TO FIRST FIRE: Remove all labels from glass. Clean gold surfaces with a glass cleanser and soft cloth
to prevent staining from fingerprint oils.
IMPORTANT! Record serial number of your stove on the warranty card and mail immediately.
The serial number is located on the safety label affixed behind the left side curtain on
the outside of hopper wall.
250-5583 October 10, 2001