Hans Grohe 04167XX0 Manuale Utente

5

Remove the plunger assembly.
Unscrew the drain outlet flange from the 

tee.

Unscrew the tailpiece from the tee.  

Wrap the threads with Teflon tape 

and replace.

Install the flexible sealing gasket on the 

flange.  Sit it in the sink outlet.  
From below, install the black mack gasket, 

white friction ring, and retainer nut to the 

flange. Do not tighten the nut against the 

bottom of the sink at this time.
Thread the tee and tailpiece to the flange.  

The pivot must face the faucet.  If neces-

sary, turn the drain assembly.
Tighten the retainer nut.  
Sit the plunger assembly in the drain.  
Install the horizontal rod through the pivot 

ball seals and into the tee so that the end 

goes through the loop in the bottom of the 

height adjuster.  The two pivot ball seals 

should surround the pivot ball.
Slide the link over end of pull rod.  Tighten 

screw.
Slide one end of spring clip over end of 

horizontal rod.  Slide link over end of hori-

zontal rod.  Test motion of drain plunger.  

Reposition link as necessary.  There are 

multiple holes in the link -- the horizontal 

rod may go through any of the holes.
 When satisfied with the action of the drain, 

slide the other end of the spring clip over 

the end of the horizontal rod. 

plunger

flange

tailpiece

sealing gasket

mack gasket

friction ring

retainer nut

tee

pivot

horizontal 

rod

pivot ball 

pivot ball 

seals

spring 

clip

link

nut