Lightolier 26650 Dépliant

FALL RIVER, MASSACHUSETTS 02720
MONTREAL, QUEBEC, CANADA

 © 1997

Caution:
• Turn off power at fuse box before installing  track.
• Instructions for grounding Feed-in Kit must be followed.

• Use only #12 ga. solid copper wire in connectors to

• Observe polarity, white (neutral) wire must be connected

• Do not use Track as a conduit support. Independent conduit

INSTALLING CONNECTOR INTO TRACK SECTION
1. Remove Dead-End Cover if necessary by pulling it out of track

(save Dead-End Cover).

2. Push Connector into the track until there is no gap between the

track unit and connector. Ensure that the contact blades are
aligned with the copper wires in the track during assembly.

3. Tighten the locking screw(s).
4. Tighten Spline Screws.

POWER FEED TO THE CONNECTOR(S)
DIRECT POWER FEED
1. Remove the bottom cover (if required) by snapping it out of the

connector (save cover).

2. Remove K.O. plate from the connector.
3. Remove the K.O..
4. Attach the electrical connector onto the K.O. plate using the nut

provided. Align the electrical connector such that the connector is
hidden by the track width.

5. Attach the K.O. plate onto the connector using the screw that was

previously removed.

6. Pass cable or conduit through electrical connector and clamp cable

or conduit to electrical connector.

7. Form the wires to the appropriate screw terminals, cut and strip

wires and attach to the screw terminals (see wiring section of
instruction sheet).

8. Snap the bottom cover onto the connector.

The floating splice box may be used with this connector and the track.
The floating splice box can be mounted anywhere on the track (not on
the connector). The wires are passed along the top of the track and
into the connector. The floating splice box may only be used in
accessible installations. Floating Splice  Box (cat no. 26660) sold
separately. See instructions supplied with 26660 for complete
installation details.

READ AND UNDERSTAND ALL TRACK, CONNECTOR, FEED-IN-KITS, AND ACCESSORY

INSTRUCTION SHEETS BEFORE INSTALLING ANY PROSPEC™ TRACK ITEM.

This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications. To assure full compliance with codes and regulations, check with your local electrical
inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

Fig. 3

Connector

Track Unit

Bottom Cover

Fig. 1

Fig. 2

Track Unit

Dead End

Knock Out

Electrical Connector

(by Others)

K.O. Plate

Nut

In-Line Connector

Bottom Cover

Dead End

Track Unit

Installation Instructions for Recessed ProSpec™, In-Line, "L", "T", and "X" Connectors

™

Locking  Screw

Spline Screw

Track Unit