Lightolier IS:LCAWTSB Dépliant
CAUTION: Please read these instructions before installing the luminaire. To avoid electric shock, turn off the power from the electric panel before beginning. For safety, this
luminaire must be grounded. Consult an electrician to make sure all the requirements of the US or Canadian Code for electricity and the current local regulations comply.
luminaire must be grounded. Consult an electrician to make sure all the requirements of the US or Canadian Code for electricity and the current local regulations comply.
Keep these
instructions as reference.
IMPORTANT: Do not expose this luminaire to a room ambient temperature more
than 28°C. An overheating of this luminaire could reduce the performance and the
time life os the light-emitting diode (LED).
than 28°C. An overheating of this luminaire could reduce the performance and the
time life os the light-emitting diode (LED).
Note: This fixture uses a LED (Light Emitting Diode) light source,
No maintenance is required.
No maintenance is required.
A. ONE-CIRCUIT TRACK INSTALLATION:
1. Align adapter lever open on bead side. (Fig.2)
2. Align locking lever 60° counter-clockwise. (Fig.3)
3. Insert luminaire module into the track. (Fig.4)
4. Turn adapter lever clockwise. (Fig.4)
5. Turn locking lever 60°. (Fig.4)
1. Align adapter lever open on bead side. (Fig.2)
2. Align locking lever 60° counter-clockwise. (Fig.3)
3. Insert luminaire module into the track. (Fig.4)
4. Turn adapter lever clockwise. (Fig.4)
5. Turn locking lever 60°. (Fig.4)
B. TWO-CIRCUIT INSTALLATION:
1. Lift brass contact tab approximately ¼ in. (7mm). (Fig.5)
2. Follow previous steps 1-5.
1. Lift brass contact tab approximately ¼ in. (7mm). (Fig.5)
2. Follow previous steps 1-5.
C. 4-BUTTON CONTROLLER: (Fig.6)
Note: Control button display is touch-sensitive. Touch center of pictogram, an
audible beep confirms new selection.
audible beep confirms new selection.
PRESET ( ):
a) One-touch selection changes preset up or preset down
b) Hold preset up to scroll selection in a continuous loop.
c) Hold preset down to scroll selection until selection 1.
BRIGHTNESS ( / ):
a) One-touch selection increases/reduces brightness level by 5%.
b) Hold setting to dim up/down in 5% increments every 1/5 second.
Installation Instructions for Lytespan Track LED Manual
Controller Accent Lighting Colorspot Luminaire
BEAD
FIG.1
FIG.2
FIG.3
ADAPTER
LEVER
INTERLOCKING LEVER
TRACK
ADAPTER
LEVER
LUMINAIRE MODULE
TRACK
FIG.4
BRASS CONTACT
FIG.5
PICTOGRAMS
FIG.6
ADAPTER
LEVER
LOCKING LEVER
WARNING: This luminaire is for ceiling installation on Lytespan track only. Do not install on Monopoint, Multipoint, Fast Track, Sloped Ceiling Adapter, Extension Wand or ProSpec
Track.
Track.
Canlyte 3015, Louis Amos, Lachine, Québec H8T 1C4 - Tel.: (514) 636-0670 - Fax.: (514) 636-0460 - www.canlyte.com
Lightolier 631 Airport Road, Fall River, MA 02720, - Tel.: (508) 679-8131 - Fax.: (508) 674-4710 - www.lightolier.com
IS:LCAWTSB
10-08/Rev-01
Lightolier is a Philips group brand