Lightolier IS:48021 Dépliant

Instruction Sheet Number  

Page

For Assembly and Installation of Soli ADA Series Wall/Ceiling Mounted T-5 Fluorescent

a Genlyte Thomas Companywww.lightolier.com

631 Airport Road, Fall River, MA 02720  (508) 679-8131  Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2003 Genlyte Thomas Group LLC (Lightolier Division)  A0403

1.  Pull supply wires from OUTLET BOX through hole in

MOUNTING PLATE (Fig.1). Secure MOUNTING PLATE to
OUTLET BOX using screws provided with OUTLET BOX.

2.  Insert  tabs from OUTLET BOX COVERS into slots on

MOUNTING PLATE to enclose OUTLET BOX.

3.  Pull supply wires through center hole in BACK PLATE . Align

BACK PLATE and mark holes for DRYWALL ANCHORS
(supplied), screw DRYWALL ANCHORS into wall.

4.  Secure BACKPLATE to MOUNTING PLATE and DRYWALL

ANCHORS using screws provided.

5.  While supporting BALLAST HOUSING, Make electrical

connections: Black lead or lead without tracer marks to
hot (Black) supply lead; White lead or lead with tracer
marks to neutral (White) supply lead. Uninsulated wire is
a ground wire and must be connected to grounding
terminal or ground lead inside OUTLET BOX.  Use WIRE
NUTS.

6.  Carefully push connections back into the OUTLET BOX.
7.  Align tabs at top of BALLAST HOUSING with slots on BACK

PLATE, snap in and push housing flush with wall.

PINCHED  BETWEEN MOUNTING PLATE AND FIXTURE 
BODY.
8.  Insert ALLEN HEAD SCREW (provided) into hole at bottom

of BALLAST HOUSING and fasten BALLAST HOUSING to
BACK PLATE (Fig. 1)

Glass Diffuser:  Secure DIFFUSER to BALLAST HOUSING 

with Philips head glass mounting screws 

(provided) 

See Figs. 1 & 2.

1.  Press PROTECTIVE BUSHINGS (supplied) through holes in

ACRYLIC DIFFUSER.

2.  Proceed as above Glass Diffuser instructions.

NOTE: If fixture is to be mounted without DIFFUSER, insert 

gray  plastic push-in plugs (supplied) to cover glass mtg.holes in

BALLAST HOUSING. 

C.  FOR FRONT COVER ATTACHMENT
1.  After inserting Lamp, Snap the FRONT COVER onto end caps

of BALLAST HOUSING (Fig. 1).

2.  Insert ALLEN HEAD SCREWS into the holes at both ends of

the fixture to secure front cover to BALLAST HOUSING.

D.  To remove glass / acrylic for cleaning
1.  Remove FRONT COVER by unscrewing ALLEN HEAD

SCREWS at both end caps and unsnap FRONT COVER from
end caps.

2.  Remove lamp by rotating 90 degrees and gently pulling it out of

the sockets.

3.  Unfasten DUFFUSER (if used) from the BALLAST HOUSING.

Glass: clean with a small amount of glass cleaner on soft   

cloth to remove hand oils and dirt.

Acrylic: clean with mild soap and water

.

1 of 2

This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance 
with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity 
at fuse box before proceeding.