Lightolier 8605 Dépliant

2000

INSTRUCTION SHEET NO.

A0300 Page 1of 1

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications. To assure full compliance with codes and regulations, check with your local electrical
inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

631 Airport Road, Fall River, MA 02720

LIGHTOLIER a GENLYTE THOMAS company.

IS:8605

POINT POWER JACK FOR 8600 LYTEJACK FIXTURES

NOTE: ACCESS ABOVE CEILING OR BEHIND WALL REQUIRED DURING INSTALLATION.

POINT

POWER

JACK

LEADS (2)

SPRING TAB

LABEL ON BOTTOM

OF FLANGE

MAXIMUM WATTAGE LABELS

ATTACH AT INSTALLATION

GAP

CAPS

FLANGE

IF THE CEILING OR WALL IS MADE FROM A DENSE MATERIAL SUCH
AS 1/2” PLYWOOD OR 3/4” PLASTERBOARD AND IS FIRMLY
ATTACHED TO SUBSTANTIAL STRUCTURE THEN THE POINT POWER
JACK CAN BE MOUNTED DIRECTLY TO THE CEILING OR WALL AS
SHOWN BELOW.

(* IF THE CEILING OR WALL DOES NOT MEET THESE
REQUIREMENTS, USE T-BAR ACCESSORY NO.8618).

NOTE: THE MAXIMUM WATTAGE LABEL SELECTED FOR THIS
POWER JACK MUST CORRESPOND TO THE MARKINGS ON THE
TRANSFORMER LABEL.

1. Peel the appropriate MAXIMUM WATTAGE LABEL from its backing

and adhere it to the gap in the LABEL on the FLANGE of the
POINT POWER JACK (Fig. 1).

2. Select the CAP with the same MAXIMUM WATTAGE marking and

snap it over the FLANGE (Fig. 2).

NOTE: Use the 35W MAXIMUM WATTAGE LABEL and CAP for

fixtures that have screw-in adapters (Fig. 2).

FIG. 1

FIG. 2